BUILDING UTILITIES 1 (L1-L2)

PLUMBING

IT REFERS TO THE SYSTEM OF PIPES, FITTINGS, AND FIXTURES INSTALLED IN BUILDING FOR THE DISTRIBUTION OF POTABLE WATER FOR DRINKING, HEATING, AND WASHING, AND REMOVAL OF WATERBORNE WASTES.

TO SUPPLY WATER TO DIFFERENT PARTS OF THE BUILDING & TO REMOVE AND DISCHARGE HUMAN WASTES AND OTHER SUBSTANCES

WHAT ARE THE OBJECTIVES OF PLUMBING?

SUFFICIENT AMOUNT OF WATER

CONDITIONS OF EFFECTIVE WATER SUPPLY IN BUILDING;

TO PROVIDE _____________ TO SUPPLY EACH FIXTURE.

PREVENT BACKFLOW OF USED WATER

CONDITIONS OF EFFECTIVE WATER SUPPLY IN BUILDING;

TO _____________ INTO THE WATER SUPPLY SYSTEM.

FAST REMOVAL OF WASTE

_________________ WITH MINIMUM PROBABILITY OF LEAKAGE AND STOPPAGE OF DRAINS.

PREVENT ENTRY OF HOUSE VERMIN AND OBNOXIOUS GASES

TO _____________ INTO THE HOUSE FROM THE PIPPING SYSTEM.

PURE AND WHOLESOME WATER

ALL PREMISES INTENDED FOR HUMAN HABITATION, OCCUPANCY OR USE SHALL BE PROVIDED WITH SUPPLY OF _____________, NEITHER CONNECTED WITH UNSAFE WATER SUPPLIES NOR SUBJECT TO HAZARDS OF BACKFLOW OR SIPHONAGE.

SUFFICIENT VOLUME AND AT PRESSURE ADEQUATE

PLUMBING FIXTURES, DEVICES AND APPURTENANCES SHALL BE SUPPLIED WITH WATER IN _______________________ TO ENABE THEM TO FUNCTION SATISFACTORILY AND WITHOUT UNDUE NOISE UNDER ALL NORMAL CONDITIONS OF USE.

MINIMUM QUANTITY OF WATER

PLUMBING SHALL BE DESIGNED AND ADJUSTED TO USE THE _______________ CONSISTENT WITH PROPER PERFORMANCE AND CLEANING.

DANGERS FROM EXPLOSION

DEVICES FOR HEATING AND STORING WATER SHALL BE SO DESIGNED AND INSTALLED AS TO PREVENT __________________ THROUGH OVERHEATING.

PUBLIC SEWER

EVERY BUILDING HAVING PLUMBING FIXTURES INSTALLED AND INTENDED FOR HUMAN HABITATION, OCCUPANCY OR USE ON PREMISES ABUTTING ON A STREET, ALLEY OR EASEMENT WHERE THERE IS A _____________, SHALL BE CONNECTED INTO THE SEWER SYSTEM.

ONE WATER CLOSET & ONE KIT. TYPE SINK

EACH FAMILY DWELLING UNIT ON PREMISES ABUTTING ON A SEWER OR WITH A PRIVATE SEWAGE DISPOSAL SYSTEM SHALL HAVE AT LEAST ________________.

SMOOTH, NON-ABSORBENT MATERIALS

PLUMBING FIXTURES SHALL BE MADE OF _____________________, FREE FROM CONCEALED FOULING SURFACES AND SHALL BE LOCATED IN VENTILATED ENCLOSURES.

ADEQUATE CLEANOUTS

THE DRAINAGE SYSTEM SHALL BE DESIGNED, CONSTRUCTED AND MANTAINED TO SAFEGUARD AGAINST FOULNG, DEPOSIT OF SOLIDS, CLOGGING AND WITH ________________ SO ARRANGED THAT THE PIPELINES MAY READILY CLEANED

DURABLE & APPROVED MATERIALS

ALL PIPING OF PLUMBING SYSTEMS SHALL BE OF ___________________, FREE FROM DEFECTIVE WORKMANSHIP, DESIGNED AND CONSTRUCTED BY REGISTERED MASTER PLUMBER TO EMSURE SATISFACTORY SERVICE

WATER-SEALED TRAP

EACH FIXTURE DIRECTLY CONNECTED TO THE DRAINAGE SYSTEM SHALL BE EQUIPPED WITH A ______________.

ADEQUATE CIRCULATION OF AIR

THE DRAINAGE PIPING SYSTEM SHALL BE DESIGNED TO PROVIDE _________________ FREE FROM SIPHONAGE, ASPIRATION OR FORCING OF TRAP SEALS UNDER ORDINARY USE.

VENT TERMINALS

__________________ SHALL BE EXTENDED TO THE OUTER AIR AND INSTALLED TO PREEMPT CLOGGING AND RETURN OF FOUL AIR TO THE BUILDING.

EFFECTIVELY DISCLOSE ALL LEAKS AND DEFECTS

PLUMBING SYSTEMS SHALL BE SUBJECTED TO SUCH TESTS TO ______________ IN THE WORKMANSHIP.

PRODUCE EXPLOSIVE MIXTURES

NO SUBSTANCE WHICH WILL CLOG THE PIPES, ______________, DESTROY THE PIPES OT THEIR JOINTS OR INTERFERE UNDULY WITH THE SEWAGE DISPOSAL PROCESS SHALL BE ALLOWED TO ENTER THE BUILDING DRAINAGE SYSTEM.

BACKFLOW OF SEWAGE

PROPER PROTECTION SHALL BE PROVIDED CONTAMINATION OF FOOD, WATER, STERILE GOODS AND SIMILAR MATERIALS BY _____________.

LIGHTED OR VENTILATED

NO WATER CLOSET SHALL BE LOCATED IN A ROOM OR COMPARTMENT WHICH IS NOT PROPERLY _________________.

SEWAGE TREATMENT AND DISPOSAL

IF WATER CLOSETS OR OTHER PLUMBING FIXTURE ARE INSTALLED IN BUILDINGS WHERE THERE IS NO SEWER WITH A REASONABLE DISTANCE, SUITABLE PROVISION SHALL BE MADE FOR DISPOSING OF THE BUILDING SEWAGE BY SOME ACCEPTANCE METHOD OF ________________, SUCH AS SEPTIC TANK

PREVENT ITS OVERFLOW

WHERE A PLUMBING DRAINAGE SYSTEM MAY BE SUBJECT TO BACKFLOW OF SEWAGE, SUITABLE PROVISION SHALL BE MADE TO ______________________ IN THE BUILDING.

SERVICEABLE CONDITION

PLUMBING SYSTEMS SHALL BE MAINTAINED IN _______________ BY REGISTERED MASTER PLUMBERS

PROPERLY SPACED

ALL PLUMBING FIXTURES SHALL BE INSTALLED _______________, TO BE ACCESSIBLE FOR THEIR INTENDED USE.

PRESERVATION OF THE STRENGTH

PLUMBING SHALL BE INSTALLED BY REGISTERED MASTER PLUMBERS WITH DUE REGARD TO THE ________________ OF STRUCTURAL MEMBERS AND THE PREVENTION OF DAMAGE TO WALLS AND OTHER SURFACES THROUGH FIXTURE USAGE.

RENDERED INNOCUOUS

SEWAGE OR OTHER WASTE FROM A PLUMBING SYSTEM WHICG MAY BE DELETERIOUS T SURFACE OR SUB SURFACE WATER SHALL NOT BE DISCHARGE INTO THE GROUND OR INTO ANY WATERWAY, UNLESS FIRST _____________ THROUGH SUBJECTION TO SOME ACCEPTABLE FORM OF TREATMENT.

17TH CENTURY

THE BIRTH OF PLUMBING PROFESSION

WALLED CITY

KNOWN AS INTRAMUROS WAS ESTABLISHED BY THE SPANIARDS AS A MODEL COMMUNITY

ILUSTRADOS

THE RECOGNIZED PLUMBERS THEN WERE CALLED UPON BY THE ________________, OR THE ELITE GROUP TO ACT AS CONSULTANTS OF PLUMBER JOURNEYMEN ON MATTERS PERTAINING TO PLUMBING INSTALLATION IN VILLAS AND MANSION

PUEBLOS

IN 18TH AND 19TH CENTURY, FILIPINO PLUMBERS WERE ASSIGNED THE TASK OF MAINTANING, REPAIRING AND REMODELING SYSTEMS IN ALL ___________ OR TOWNS INCLUDING CHURCHES, CONVENTS AND GOVERNMENT BUILDINGS.

EL DEPOSITO

THE CARVERNOUS, ONE OF THE OLDEST UNDERGROUND RESERVOIRS IN THE WORLD ADN THE COUNTRY’S LARGEST SPANISH ERA ARTIFACT, WAS BUILT AS PART OF THE CARRIEDO WATERWORKS WAS BUILT FROM 1878 TO 1882

GOVERNOR GENERAL F.B. HARRISON

HE ISSUED A LETTER OF INSTRUCTION ON PROPER DISPOSAL IN ALL MUNICIPALITIES

20TH CENTURY

HEALTH AND HYGIENCE BECAME PRIORITY WHEN EPIDEMICS INCLUSDING CHOLERA, LEPROSY, SCHISTOSOMIASIS AND OTHER CONTAGIOUS DISEASE ENGULFED THE PHILIPPINES

SANITARY ENGINEER

APPLICATION OF ENGINEERING METHODS TO IMPROVE SANITATION OF HUMAN COMMUNITIES

MASTER PLUMBER

A LICENSE PERSON SPECIALIZE IN WATER, SEWAGE ADN DRAINAGE SYSTEMS USUALLY IN RESIDENTIAL AND COMMERCIAL ESTABLISHMENT

PLUMBER

A TITLE GVEN TO A PERSON WHO IS SKILLED THAT INSTALLS OR REPAIRS PIPING SYSTEM ALOSO KNOWN AS JOURNEYMAN

1902

YEAR OF WHEN PLUMBING TRADE WAS DULY RECOGNIZED BY THE GOVERNMENT

JOHN F. HASS

THE MASTER PLUMBER WHO BECAME THE FIRST CHIEF OF THE DIVISION OF PLUMBING CONSTRUCTION AND INSPECTION.

BUILDING CODE FOR THE CITY OF MANILA

THROUGH THE INITIATIVE OF THE FILIPINO MASTER PLUMBERS, A PLUMBING CODE BASED ON THE PLUMBING CODE OF THE UNITED STATES WAS INCORPORATED

1935

YEAR WHERE (NAMPAP) WAS FOUNDED REGISTERED WITH THE SECURITIES AND EXCHANGE COMMISION?

NATIONAL MASTER PLUMBING ASSOCIATION OF THE PHILIPPINES

WHAT IS THE MEANING OF THE ACRONYM OF NAMPAP?

DEPARTMENT OF PUBLIC SERVICES

MANILA CITY ORDINANCE 2411, OTHERWISE KNOWN AS “THE PLUMBING CODE FOR THE CITY OF MANILA” WAS ENACTED IN CONSUKTATION WITH NAMPAP. THE PRACTICE OF PLUMBING WAS EVENTUALLY PLACED UNDER THE ________________.

DECEMBER 21, 1999

DATE WHERE PRESIDENT JOSEPH EJERCITO ESTRADA APPROVED THE PURSUANT TO SECTION 4 OF R.A. 1378 KNOWN AS PLUMBING LAW

1972

REPUBLIC ACT NO. 6541 OTHERWISE KNOWN AS BUILDING CODE OF THE PHILIPPINES WAS PASSED WITH THE NATIONAL PLUMBING CODE OF 1959 AS REFERRAL IN FULL TEXT

JAIME M. CABASE

NAMPAP PRESIDENT WHO IS SPEARHEADED THE UPDATING REVISED NATIONAL PLUMBING CODE

OCTOBER 1999

DATE AS TO WHEN NAMPAP SUBMITTED THE DRAFT CODE TO THE BOARD MASTER PLUMBERS (BOMP) CHAIRED BY ENGR. FORTUNATO H. AMOSCO

HERMOGENES POBRE

THE PRC CHAIRMAN WHO ADOPTED THE REVISED PLUMBING CODE OF 1999

HOUSE BILL NO. 962

THE THIRD CONGRESS OF THE REPUBLIC OF THE PHILIPPINES APPROVED THE _________________, WHEREIN THIS BECAME REPUBLIC ACT NO. 1378.

PLUMBING LAW OF THE PHILIPPINES

JUNE 18, 1955, R.A. 1378, OTHERWISE KNOWN AS THE __________________ BY PRESIDENT RAMON MAGSAYSAY

NOVEMBER 28, 1967

FIRST AMENDMENT TO THE NATIONAL PLUMBING CODE WAS APPROVED, WHICH EFFECTED THE INCLUSION PF ABESTOS-CEMENT PIPE AS AN APPROVED PLUMBING MATERIAL

NAWASA

NAMPAP ALSO ASSISTED IN THE PASSAGE OF THE LAW CREATING THE ______________________.

JANUARY 28, 1959

DATE WHEN NATIONAL PLUMBING CODE OF THE PHILIPPINES PREPARED BY NAMPAP WAS PROMULGATED AND APPROVED BY MALACAÑANG

FEATI UNIVERSITY

IN 1966-1969, THE BOARD OF EXAMINERS FOR MASTER PLUMBERS AND THE NAMPAP PREPARED A CURRICULUM FOR PLUMBING ENGINEERING THAT WAS APPROVED THE DEPARTMENT OF EDUCATION AND WAS FIRST INTRODUCED AT THE _______________.