Routing&SwitchingT2

Refer to diagram7.svg. Which two route sources have higher preference?

Static route

Connected route

Refer to the exhibit. Based on the partial output from the show ip route command, what two facts can be determined about the RIP routing protocol? (Choose two.)

The command no auto-summary has been used on the RIP neighbor router.

RIP version 2 is running on this router and its RIP neighbor.

What is a static route?

A manually configured route by an administrator

How fast does Rapid PVST+ typically converge after a topology change?

Less than 10 seconds

Which are advantages of RSTP over classic STP? (Choose two)

Fewer port states

Faster convergence

What are two advantages of using LACP? (Choose two.)

It allows the use of multivendor devices.

It allows directly connected switches to negotiate an EtherChannel link.

On which two routers would a default static route be configured? (Choose two.)

stub router connection to the rest of the corporate or campus network

edge router connection to the ISP

What is the IPv6 loopback address?

::1

FE80::/10
FF00::/8
2000::/3
FC00::/7

Link local addresses used on a single link

multicast address space

global unicast

unique local address (private ipv6)

Select two valid IPv6 address types.

Multicast,Unicast

The graphic shows some partial output of the show ipv6 route command:
Refer to the exhibit. What two conclusions can be drawn based on the output of the show ipv6 route command? (Choose two.)

Route 2001:DB8:CAFE:B001::/64 is a route advertised by an ABR.

R2 receives default route information from another router.

Which are categories of dynamic routing protocols? (Choose two)

Distance-vector

Link-state

What is the primary purpose of a floating static route?

Serve as a backup route that becomes active when preferred routes are absent

A new network administrator has been asked to verify the metrics that are used by EIGRP on a Cisco device. Which two EIGRP metrics are measured by using static values on a Cisco device? (Choose two.)

bandwidth

delay

Adapts to topology changes automatically
Manual configuration required
Low overhead, no routing updates 
Requires CPU and bandwidth resources

Dynamic Routing
Static Routing
Static Routing

Dynamic Routing

Refer to the exhibit. A network administrator is configuring an EtherChannel link between two switches, SW1 and SW2. However, the EtherChannel link fails to establish. What change in configuration would correct the problem?

Configure SW2 EtherChannel mode to desirable.

What information is stored in a routing table?

Network destinations and next-hop addresses

Convergence
Administrative Distance

Metric

Routing Table

state routers share consistent routing info

router-local preference for route source selection

value used by a protocol to pick best path

repository of installed routes on a router

Refer to diagram9.svg. Which two statements about EIGRP AS configuration are correct?

Routers must share the same AS number to become neighbors.

Redistribution is required between different AS numbers

What is administrative distance used for in routing?

To rank trustworthiness of routing information sources

Which mechanism allows a host to autoconfigure an IPv6 address using router advertisements?

Stateless Address Autoconfiguration (SLAAC) via ICMPv6 Router Advertisement

Which two factors does an EIGRP router use to determine that a route to a remote network meets the feasible condition and is therefore loop-free? (Choose two.)

the feasible distance on the local router

the reported distance on a neighbor router

Select two items that are commonly configured for a floating static route.

Higher administrative distance than primary route

Next-hop IP or outgoing interface

In which two PVST+ port states are MAC addresses learned? (Choose two.)

forwarding

learning

Refer to the exhibit. A ping from R1 to 10.1.1.2 is successful, but a ping from R1 to any address in the 192.168.2.0 network fails. What is the cause of this problem?

The static route for 192.168.2.0 is incorrectly configured.

What network prefix and prefix-length combination creates a default static route that matches any IPv6 destination?

: :/0

Select all valid RSTP port roles. (Choose two)

Alternate

Root

Which statements about RSTP edge ports are correct? (Choose two)

They transition immediately to forwarding state

They connect directly to end devices

What are two load-balancing methods in the EtherChannel technology? (Choose two.)

source MAC to destination MAC

source IP to destination IP