Create molded parts

Which command would you use to apply taper or slope to faces, bodies, or from edges? Soft Blend | Draft | Chamfer | Face Angle

Draft

What feature can be used to create stiffening geometry to support other features? Rib | Shell | Extrude | Gusset

Rib

The Draft command is typically used to apply what to faces? Extrude | Offset | Hollow | Slope

Slope

Which type of object can you add a rib into? Solid Body | Sheet Body | Datum Plane | Assembly Component

Solid Body

Which one of these is not a type of creation in the Face Blend command? Two-face | Three-face | Face and Vector | Feature Intersection Edge

Face and Vector

Which one of these command is the most efficient and preferable way to create stiffeners on molded parts? Extrude | Rib | Thicken | Flange

Rib

The Rib feature can only be created in what situation? In a pocket area were the rib extends down and to the side walls | There is no restriction on where ribs can be created | Must be created on the top of a model and projected down to the surface | Can only can be created on surface bodies

In a pocket area were the rib extends down and to the side walls

To create a blend between three faces at the same time, what command would you use? Edge Blend | Styled Blend | Aesthetic Face Blend | Face Blend

Face Blend

What command could be used to create a hollow molded part? Hollow | Shell | Subtract | Split Body

Shell

What is a unique ability of Face Blend over Edge Blend? Can create a blend between two connected faces | Can create a blend between two faces that are not connected | Can create a blend that is G1 tangent | Can create a blend that is G2 curvature

Can create a blend between two faces that are not connected

What option in the extrude dialog will project an extrude to the side walls of a pocket? Open Profile Smart Volume | Draft | Offset | Direction

Open Profile Smart Volume

When creating an offset curve, how do you switch from sharp corners to a radius corner based off the offset value? Change the Cap Option to Extension Cap | This cannot be done | Change the Cap Option to Arc Cap | Select Symmetric Offset

Change the Cap Option to Arc Cap