Unit 3: Firearms and Toolmarks

### Microscopes →Which is used for bullet comparison?

A comparison microscope is used for bullet comparison.

### Which mircoscope uses electrons?

A microscope that uses electrons is the *SEM – scanning e- microscope.*

### What is rifling?

Rifling – the spiral grooves that are formed in the bore of a firearm barrel. Makes the projectile spin when fired.

### Individual characteristics of a firearm

### Individual

* Striae
* Firing pin marks
* Breech marks
* Extractor marks
* Ejector marks
* Chamber marks

### Class characteristics of a firearm

### Class

* Bullet type
* Bullet caliber
* Bullet weight
* Lands and grooves
* Rifling
* Cartridge case
* Headstamp

### How could you make a match→ suspect bullet vs. known bullet

To match bullets to a gun, test bullets must be fired through a suspect barrel for comparison. • Goddard & Comparison Microscopes – Examined bullets sideby-side (to match striated markings).

### GSR→ element composition? (composition compared to explosive residue?)

GSR= lead, antimony, and barium.

### Colour test for presence of lead?

To confirm the presence of lead, the Sodium Rhodizonate Test is used.

Contact shot

Powder burns are present, and clothing and skin may be torn from the introduction of gases, stippling inside the wound.

Distant shot

no powder burns on the skin, no pieces of unburnt powder (called stippling), a slight grey smudge around the entrance wound called bullet to wipe (lubricant, lead, powder, and other materials).

Near Contact shot

powder burns on skin, clothing and hair, stippling is present in a very narrow area, bullet wipe hard to see because of other materials present.

### Microscope used for toolmark comparison?

The comparison microscope

### Do you put suspect tool into known impression?

Under no circumstances must the crime scene investigator attempt to fit the suspect tool into the tool mark. Any contact between the tool and the marked surface may alter the mark and will, at the least, raise serious questions about the integrity of the evidence.

### How are impressions made (hard vs. soft metal)

The hardness of a tool influences the resulting marks left on the softer object.

Indentation marks are made when a tool is pressed against a softer surface.