Tell me questions UK driving test

1. Tell me how you'd check that the brakes are working before starting a journey.

Brakes should not feel spongy or slack. Brakes should be tested as you set off. The vehicle should not pull to one side.

2. Tell me where you'd find the information for the recommended tyre pressures for this car and how tyre pressures should be checked.

Check the manufacturer's guide for the correct pressures, then use a reliable gauge to check and adjust all tyres, when they're cold.

3. Tell me how you make sure your head restraint is correctly adjusted so it provides the best protection in the event of a crash.

The head restraint should be adjusted so the rigid part is at least as high as the eyes or top of the ears, and as close to the back of the head as is comfortable.

4. Tell me how you'd check the tyres to ensure that they have sufficient tread depth and that their general condition is safe to use on the road.

No cuts or bulges, and at least 1.6mm of tread depth across the central three

5. Tell me how you'd check that the headlights and tail lights are working. You don't need to exit the vehicle.

Operate the switch (turning on the ignition if necessary), then walk round the vehicle to check.

6. Tell me how you'd know if there was a problem with your anti-lock brake system

Warning light should illuminate if there is a fault with the anti-lock braking system.

7. Tell me how you'd check the direction indicators are working. You don't need to exit the vehicle.

Operate the switch (turning on the ignition if necessary), then walk round the vehicle to check.

8. Tell me how you'd check the brake lights are working on this car.

Operate the brake pedal and use reflections in windows or doors, or ask someone to check for you.

9. Tell me how you'd check the power-assisted steering is working before starting a journey

Apply gentle pressure to the steering wheel as you start the engine, or turn it just after moving off - you should feel the power assistance engage.

10. Tell me how you'd switch on the rear fog light(s) and explain when you'd use it/them. You don't need to exit the vehicle.

Operate the switch, check the warning light comes on, and it's used in fog when visibility drops below 100 metres.

11. Tell me how you switch your headlight from dipped to main beam and explain how you'd know the main beam is on.

Operate the switch (with ignition or engine on if necessary), and check the main beam warning light is lit.

12. Open the bonnet and tell me how you'd check that the engine has sufficient oil.

Identify the dipstick or oil level indicator, and check the oil level sits between the minimum and maximum markers.

13. Open the bonnet and tell me how you'd check that the engine has sufficient engine coolant.

Check the coolant level sits between the high and low markings on the header tank.

14. Open the bonnet and tell me how you'd check that you have a safe level of hydraulic brake fluid.

Identify the fluid reservoir and check the level sits between the high and low markings.