1/9
Looks like no tags are added yet.
Name | Mastery | Learn | Test | Matching | Spaced | Call with Kai | Chat |
|---|
No analytics yet
Send a link to your students to track their progress
heater core
An evaporator is being replaced on a vehicle. It is recommended that the _________ also be replaced at the same time.
a. blower motor
b. heater core
c. radiator
d. blower resistor
Technician A only
Two technicians are discussing replacing heater hoses. Technician A says that the replacement hoses should be the same length as the original hoses. Technician B says that the replacement hoses should be cut as short as possible to allow more coolant to flow through the heater core faster. Which technician is correct?
a. Technician A only
b. Technician B only
c. Both Technicians A and B
d. Neither Technician A nor B
The refrigerant should be identified
What service procedure should be performed before recovering refrigerant from an A/C system?
a. Flush the radiator
b. The refrigerant should be identified
c. Recover all of the refrigerant oil
d. Replace the drier
Either a or c
O-rings are usually made from ________.
a. HSN
b. natural rubber
c. neoprene
d. Either a or c
Quick-disconnect valves
What type of service valves are used with R-134a?
a. Schrader valves
b. Gate valves
c. Quick-disconnect valves
d. Saddle valves
500 microns
Which reading represents the lowest vacuum reading?
a. 27-in. Hg
b. 28-in. Hg
c. 29-in. Hg
d. 500 microns
Air
What is a noncondensable gas?
a. Air
b. R-12
c. Ozone
d. R-134a
Technician B only
Technician A says that all orifice tubes on all vehicles use the same orifice size. Technician B says that orifice tubes vary the orifice size by application. Which technician is correct?
a. Technician A only
b. Technician B only
c. Both Technicians A and B
d. Neither Technician A nor B
Both a and b
Which part must be used when refitting a vehicle from R-12 to R-134a refrigerant?
a. A new (larger) condenser
b. A new service fitting and a retrofit label
c. A high-pressure cut-off switch
d. Both a and b
Whenever the system is opened for service
When should the accumulator be replaced with a new one?
a. Whenever the system is opened for service
b. Every 5 years
c. Whenever the engine cooling system is flushed
d. It never needs changing