1/21
Vocabulary flashcards covering key DC circuit terms, laws, theorems, and definitions based on the lecture materials.

Resistance
The opposition offered by a substance to the flow of electric current, measured in ohms (Ω) and denoted by R or r. Mathematically expressed as R=ρal.

Inductance
The property of a material to store energy in the form of magnetic energy, which opposes any change in direction or magnitude of current flowing through a coil. Mathematically expressed as V=L(dtdI) and measured in Henrys (H).

Capacitance
The capability of a two-terminal element to store charge and energy in the form of voltage, defined as C=VQ in farads (F), with current given by I=C(dtdV).
Voltage Source
A passive two-terminal element that creates a continuous force for the movement of electrons through a connected wire.
Direct Voltage Source
A voltage source that produces or delivers a constant voltage output with electron flow and polarity remaining in one direction over time.
Branch
A single element in an electrical circuit, such as a voltage source or a resistor, representing any two-terminal element.
Node
The point of connection between two or more branches in an electrical circuit.
Loop
Any closed path in a circuit formed by starting at a node, passing through a set of nodes, and returning to the starting node without passing through any node more than once.
Kirchhoff's Current Law (KCL)
A law stating that the total current or charge entering a junction or node is equal to the charge leaving the node, or that the algebraic sum of all currents entering and leaving a node is zero (Iexiting+Ientering=0).
Kirchhoff's Voltage Law (KVL)
A law stating that in any closed loop network, the total voltage around the loop is equal to the sum of all the voltage drops within that loop, making the algebraic sum of all voltages equal to zero.
Star-Delta Transformation
A network transformation where the value of a resistor on any side of a delta network is the sum of all two-product combinations of resistors in the star network divided by the star resistor located directly opposite to it.
Delta-Star Transformation
A network transformation used to convert a delta network to an equivalent star network, where each star resistor equals the product of the two adjacent delta resistors divided by the sum of all three delta resistances (A+B+C).
Thevenin's Theorem
A theorem stating that any linear active network consisting of independent or dependent sources and circuit elements can be replaced by an equivalent voltage source (VTH) in series with a resistor (RTH).
Thevenin Voltage (VTH)
The open-circuit voltage (VOC) measured across the two open-circuited load terminals of a circuit network.
Thevenin Resistance (RTH)
The equivalent resistance of a network as viewed from its two open load terminals, with all independent sources replaced by their internal resistances.
Norton's Theorem
A theorem stating that a linear active network with independent or dependent sources and circuit elements can be substituted by an equivalent circuit consisting of a current source (ISC) in parallel with an internal resistance (Rint).
Short-Circuit Current (ISC)
The short-circuited current flowing across the shorted load terminals in Norton's equivalent circuit, also referred to as Norton Current (IN).
Electric Current
The rate of flow of electrons in a conductor, with the SI unit of Ampere (A).
Electric Potential
The amount of work done per unit charge to move that charge from infinity to a point in an electrostatic field against the field force, measured in volts (V).
Potential Difference
The amount of work required to transfer a unit charge from one place to another within an electric field.
Electric Power
The rate of doing work, measured in watts (W) representing 1 joule per second (1W=1J/s), calculated as Power (P)=Voltage (V)×Current (I).
Ohm's Law
A law stating that the ratio of potential difference (V) between any two points on a conductor to the current (I) flowing between them is constant provided temperature remains unchanged (IV=R).