AI free study guide flash cards notes

0.0(0)
Studied by 0 people
call kaiCall Kai
learnLearn
examPractice Test
spaced repetitionSpaced Repetition
heart puzzleMatch
flashcardsFlashcards
GameKnowt Play
Card Sorting

1/42

encourage image

There's no tags or description

Looks like no tags are added yet.

43 Terms

1
New cards

What is the required clearance for service drops over walkways, patios, or the ground?

10 feet.

2
New cards

How high must service drops be above swimming pools?

22 ½ feet.

3
New cards

What is a drip loop used for in service wires?

To prevent water from entering the service head.

4
New cards

What wire gauge is used for a 200-amp copper service entrance?

2/0 AWG.

5
New cards

What is a critical inspection step for sub-panels?

Ensure there are 4 wires and grounds and neutrals are not connected.

6
New cards

Where are GFCIs required?

Bathrooms, kitchens, garages, outdoors, and unfinished basements.

7
New cards

What are Federal Pacific Electric (FPE) 'Stab-lok' breakers known for?

Safety issues, usually identified by red writing on the breaker tab.

8
New cards

What materials are used for roofs with less than a 2:12 slope?

Membrane or built-up type materials.

9
New cards

What do cedar shakes require in terms of slope?

A minimum slope of 4:12.

10
New cards

What is a safety precaution for specialty roofs?

Do not walk on wood, metal, slate, cedar, clay, or other specialty roofs.

11
New cards

What should be inspected around roof flashing?

Ensure flashing is properly sealed and free of corrosion.

12
New cards

What is the maximum opening for a perimeter railing?

4 inches.

13
New cards

How high should perimeter railings be for decks higher than 30 inches?

At least 36 inches.

14
New cards

What are weep holes?

Should be spaced 32 inches apart for brick veneer siding.

15
New cards

What is the minimum height for siding above the ground?

6 inches.

16
New cards

What is the maximum height of a garage electric eye?

No more than 4 inches.

17
New cards

What are the requirements for stair riser height and difference?

Risers should be 7” to 8”, with less than a 3/8” difference.

18
New cards

What are safety glass requirements?

Required within 24 inches of doors, 60 inches above floors, and near tubs or showers.

19
New cards

What is the minimum tread depth for stairs?

9 inches.

20
New cards

What is the required drain size for a kitchen sink?

1 ½ inches.

21
New cards

What is Polybutylene (PB) piping known for?

A type of grey piping known for its high failure rate.

22
New cards

What is the minimum clearance for plumbing vents from operable windows?

10 feet away and at least 2 feet above.

23
New cards

What is the maximum length for a straight dryer vent pipe?

35 feet, subtracting 5 feet for each 90-degree elbow.

24
New cards

What safety feature must be installed with water heaters in garages?

A bollard to protect against vehicle damage.

25
New cards

What are venting requirements for water heaters?

Vents must terminate at least 1 foot above the roof and 10 feet away from operable windows.

26
New cards

What is a dielectric union?

A fitting used to connect different metal pipes, preventing corrosion but also breaking the electrical ground.

27
New cards

Why is material compatibility important in plumbing?

To prevent galvanic corrosion when connecting dissimilar metals (e.g., copper to galvanized steel).

28
New cards

What is the minimum height for water heater relief valves?

Relief valves must be piped down to within 6 inches of the floor to prevent injury from hot water discharge.

29
New cards

What is the minimum clearance required on the side of a condenser?

12 inches.

30
New cards

What is the normal operating pressure for a steam boiler?

1/2 to 2 psi.

31
New cards

What is a tridicator?

A gauge showing pressure and temperature, often found on circulated boilers.

32
New cards

What is the operating temperature range for circulated boilers?

140°F to 160°F.

33
New cards

What is the recommended insulation for suction lines?

They should be insulated to prevent condensation and maintain efficiency.

34
New cards

What should be checked during thermostat inspections?

Ensure proper wiring connections, secure mounting, and accurate temperature calibration.

35
New cards

What should be inspected in ductwork?

Look for leaks, proper insulation, and cleanliness to maintain airflow and energy efficiency.

36
New cards

What are tips for improving HVAC energy efficiency?

Regularly replace filters, seal duct leaks, and use programmable thermostats.

37
New cards

What are the fireplace clearance requirements for combustible materials?

6 inches for materials up to 1.5 inches thick; 12 inches for materials over 1.5 inches thick.

38
New cards

What is hearth depth?

Less than 6 ft² requires 16” depth and 8” on the sides; greater than 6 ft² requires 20” depth and 12” on the sides.

39
New cards

Can different fuel types be mixed in the same chimney?

No, only the same fuels can be mixed.

40
New cards

Where should smoke detectors be installed?

Inside and outside each bedroom and on every level of the home.

41
New cards

Where should carbon monoxide detectors be installed?

Outside sleeping areas and on every level of the home.

42
New cards

What should you check during general household safety inspections?

Ensure proper installation of smoke and CO detectors, inspect for tripping hazards, and verify that escape routes are clear.

43
New cards

What is a carbon monoxide detector?

A device that alerts occupants to the presence of harmful CO gas, which is odorless and potentially lethal.