PROF PRAC CHAPTER 4

Wood

Type I construction shall be of __________ construction.

Code

In Type I, structural elements may be made of any materials permitted by the __________.

Protective

• Type II construction is wood construction with __________ fire-resistant materials.

One-hour

Type II buildings must have __________ fire-resistive rating throughout.

Fire-retardant

In Type II, permanent non-bearing partitions may use __________ treated wood.

Masonry, Wood

Type III construction is a combination of __________ and __________ construction.

One-hour

Type III buildings must be __________ fire-resistive throughout.

Incombustible

Exterior walls of Type III must be made of __________ fire-resistive construction.

Concrete

Type IV construction uses materials such as steel, iron, __________, or masonry.

Incombustible

In Type IV, walls, ceilings, and partitions must be __________ and fire-resistive.

Four

Type V construction requires __________-hour fire-resistive rating throughout.

Steel, Iron

structural elements of Type V must be made of __________, __________, concrete, or masonry.

Type / Sub-type

No change in construction type is allowed unless the building complies with the requirements of the new __________.

Building Official

A change may be allowed if approved by the __________.

Hazardous

Approval is granted if the new construction is less __________ in terms of life and fire risk.

One

Exterior walls of Type II and III must have __________ hour fire-resistive rating.

Four

Exterior walls of Type IV and V must have __________ hour fire-resistive rating.

One

Interior bearing walls and floors of Type II, III, and IV must have __________ hour fire-resistive rating.

Two

Structural frames of Type IV must have __________ hour fire-resistive rating.

Three

Structural frames of Type V must have __________ hour fire-resistive rating.

One

Exterior doors and windows must have __________ hour fire-resistive rating for all types.

Flame-spread

Interior finishes are classified based on their __________ characteristic.

Untreated

Smoke density should not exceed that of burning __________ wood.

Tunnel

The standard test used is the __________ Test.

Fifty (50)

Flame-spread proofed materials must have a rating of __________ or less.