1/39
Looks like no tags are added yet.
What is EtherChannel?
A technology that bundles multiple physical links into one logical link.
What problem does EtherChannel solve?
STP blocks redundant links, wasting bandwidth.
How does EtherChannel appear to STP?
As a single logical link.
What happens if one physical link in EtherChannel fails?
Remaining links continue forwarding traffic.
How does EtherChannel prevent loops?
Treats all bundled links as one interface, forwarding only one copy of broadcasts.
What is Layer 2 EtherChannel?
Bundles switchports (access/trunk) into one logical interface.
How does STP treat Layer 2 EtherChannel?
As one link, not blocking individual members.
What is Layer 3 EtherChannel?
Bundles routed ports (no switchport) into one logical interface with an IP address.
Which flag represents Layer 2 EtherChannel in show etherchannel summary?
S (switchport).
Which flag represents Layer 3 EtherChannel in show etherchannel summary?
R (routed port).
How does EtherChannel distribute traffic?
Using a load‑balancing algorithm per flow.
Why must frames in the same flow use the same link?
To prevent out‑of‑order delivery.
What inputs can be used for load balancing?
Source MAC, destination MAC, source IP, destination IP, or both.
Default load‑balancing method on Cisco switches?
src‑dst ip (source and destination IP).
Command to configure load balancing?
port-channel load-balance
What are the three EtherChannel configuration methods?
PAgP, LACP, Static (On).
What is PAgP?
Cisco proprietary negotiation protocol.
PAgP modes?
Desirable, auto.
Which PAgP combinations form EtherChannel?
desirable+desirable, desirable+auto.
What is LACP?
IEEE 802.3ad industry standard protocol.
LACP modes?
Active, passive.
Which LACP combinations form EtherChannel?
active+active, active+passive.
What is Static (On) mode?
Manually configured EtherChannel without negotiation.
Which Static combination works?
on+on.
Why is Static mode less preferred?
No dynamic fault detection if a link silently fails.
Command to bundle interfaces?
channel-group
What happens when you configure channel‑group?
Creates a Port‑channel interface automatically.
Command to configure the logical interface?
interface Port-channel
Where is IP address assigned in Layer 3 EtherChannel?
On the Port‑channel interface.
What must match across member interfaces?
Speed, duplex, switchport mode, VLAN settings.
Command to verify EtherChannel status?
show etherchannel summary.
Flag U in show etherchannel summary?
EtherChannel is active and in use.
Flag D in show etherchannel summary?
Port‑channel interface is down.
Flag P next to physical interface?
Port is successfully bundled in EtherChannel.
Flag s next to physical interface?
Suspended due to mismatch or error.
Command to check protocol/mode?
show etherchannel port-channel.
Command to confirm STP sees EtherChannel as one link?
show spanning-tree.
Which mode combinations form EtherChannel?
on+on, desirable+auto, active+active.
What does flag P mean in show etherchannel summary?
Interface is bundled in port‑channel.
Which parameters must match for EtherChannel?
Speed and switchport mode (access/trunk).