Etherchannel Flash

CCNA EtherChannel — Flashcards

EtherChannel Basics

1. What is EtherChannel? – A technology that bundles multiple physical links into one logical link

2. What problem does EtherChannel solve? – STP blocks redundant links, wasting bandwidth

3. How does EtherChannel appear to STP? – As a single logical link

4. What happens if one physical link in EtherChannel fails? – Remaining links continue forwarding traffic

5. How does EtherChannel prevent loops? – Treats all bundled links as one interface, forwarding only one copy of broadcasts

---

Layer 2 vs Layer 3 EtherChannel

1. What is Layer 2 EtherChannel? – Bundles switchports (access/trunk) into one logical interface

2. How does STP treat Layer 2 EtherChannel? – As one link, not blocking individual members

3. What is Layer 3 EtherChannel? – Bundles routed ports (no switchport) into one logical interface with an IP address

4. Which flag represents Layer 2 EtherChannel in show etherchannel summary? – S (switchport)

5. Which flag represents Layer 3 EtherChannel in show etherchannel summary? – R (routed port)

---

Load Balancing

1. How does EtherChannel distribute traffic? – Using a load‑balancing algorithm per flow

2. Why must frames in the same flow use the same link? – To prevent out‑of‑order delivery

3. What inputs can be used for load balancing? – Source MAC, destination MAC, source IP, destination IP, or both

4. Default load‑balancing method on Cisco switches? – src‑dst ip (source and destination IP)

5. Command to configure load balancing? – port-channel load-balance <method>

---

Configuration Protocols

1. What are the three EtherChannel configuration methods? – PAgP, LACP, Static (On)

2. What is PAgP? – Cisco proprietary negotiation protocol

3. PAgP modes? – desirable, auto

4. Which PAgP combinations form EtherChannel? – desirable+desirable, desirable+auto

5. What is LACP? – IEEE 802.3ad industry standard protocol

6. LACP modes? – active, passive

7. Which LACP combinations form EtherChannel? – active+active, active+passive

8. What is Static (On) mode? – Manually configured EtherChannel without negotiation

9. Which Static combination works? – on+on

10. Why is Static mode less preferred? – No dynamic fault detection if a link silently fails

---

Configuration Steps

1. Command to bundle interfaces? – channel-group <number> mode <mode>

2. What happens when you configure channel‑group? – Creates a Port‑channel interface automatically

3. Command to configure the logical interface? – interface Port-channel<number>

4. Where is IP address assigned in Layer 3 EtherChannel? – On the Port‑channel interface

5. What must match across member interfaces? – Speed, duplex, switchport mode, VLAN settings

---

Verification

1. Command to verify EtherChannel status? – show etherchannel summary

2. Flag U in show etherchannel summary? – EtherChannel is active and in use

3. Flag D in show etherchannel summary? – Port‑channel interface is down

4. Flag P next to physical interface? – Port is successfully bundled in EtherChannel

5. Flag s next to physical interface? – Suspended due to mismatch or error

6. Command to check protocol/mode? – show etherchannel port-channel

7. Command to confirm STP sees EtherChannel as one link? – show spanning-tree

---

Quiz Review

1. Which mode combinations form EtherChannel? – on+on, desirable+auto, active+active

2. What does flag P mean in show etherchannel summary? – Interface is bundled in port‑channel

3. Which parameters must match for EtherChannel? – Speed and switchport mode (access/trunk)