1/52
Vocabulary practice flashcards covering soil water behavior, the hydrologic cycle, and soil colloidal chemistry based on Chapters 5, 6, and 8.

Water Molecule Polarity
The characteristic of the H2O molecule resulting from its asymmetric 105∘ H−O−H bond angle, which creates an electropositive charge on the side with two hydrogen atoms and an electronegative charge on the oxygen side.
Cohesion
The attraction of water molecules to each other, primarily mediated through hydrogen bonding, allowing water molecules to form temporary, dynamic clusters in the soil solution.
Adhesion
The attraction of water molecules to solid surfaces (such as soil particles) primarily via hydrogen bonding, creating an adhesive force that diminishes rapidly with increasing distance from the solid surface.
Capillarity
The movement of water into and through soil micropores caused by adhesion to particle walls and cohesion among water molecules, described by the capillary rise equation h=r0.15 where height h in cm doubles when the pore radius r in cm is halved.
Matric Potential (ψm)
The component of soil water potential that is always negative, resulting from the attraction of water to soil solid surfaces through adhesive and capillary forces in unsaturated soil above the water table.
Hydrostatic Potential
The positive pressure potential experienced by water located below the water table within water-saturated soil horizons due to the weight of the overlying water column.
Water Table
The upper boundary of the zone of saturation beneath which soil pores are completely filled with water at a hydrostatic potential of 0kPa or greater.
Soil Saturation
The condition where all soil pores (macropores and micropores) are completely filled with water, occurring at a soil water potential of approximately 0kPa.
Field Capacity
The soil water content remaining after rapid downward drainage of gravitational water from macropores has largely ceased, typically corresponding to a matric potential of −10kPa to −30kPa.
Wilting Coefficient (Permanent Wilting Point)
The moisture content of soil at which plants wilt and can no longer recover turgidity, conventionally recognized at a water potential of −1500kPa (−15bars).
Hygroscopic Coefficient
The soil water content where moisture is held very tightly in thin films on soil colloid surfaces at a matric potential of approximately −3100kPa (−31bars), completely unavailable to higher plants.
Plant-Available Water-Holding Capacity (AWHC)
The quantity of water held by a soil between field capacity (−10kPa to −30kPa) and the wilting coefficient (−1500kPa).
Least Limiting Water Range (LLWR)
The range of soil water contents within which plant root growth is not severely restricted by soil mechanical strength (too dry and hard) or by inadequate soil aeration for root respiration (less than approximately 10% air-filled porosity).
Tensiometer
A field instrument consisting of a water-filled plastic tube with a porous ceramic tip and a vacuum gauge that directly measures soil matric potential (tension) up to about −85kPa to −100kPa.
Time-Domain Reflectometry (TDR)
An electronic method that calculates the volumetric water content of soil by analyzing the velocity of electromagnetic waves transmitted along waveguides and the resulting reflected wave patterns.
Electrical Resistance Blocks
Porous gypsum blocks containing concentric wire grid electrodes buried in the soil to measure water tension from −90kPa to −1500kPa based on electrical resistance, which is inversely related to block wetness.
Darcy's Law
A physical law governing saturated water flow stating that the rate of water movement (Q/t) through a column is directly proportional to the cross-sectional area (A), the hydraulic conductivity (Ksat), and the hydraulic potential gradient (Lψ1−ψ2).
Saturated Hydraulic Conductivity (Ksat)
A quantitative measure of the ease with which water moves through a saturated soil column under a hydraulic gradient, ranging from >1×10−2cm/s in beach sand to <1×10−8cm/s in compacted clay.
Preferential Flow (Bypass Flow)
The rapid downward movement of water and dissolved surface-applied solutes through large macropores (such as earthworm channels, root channels, or shrinkage cracks), effectively bypassing the bulk soil matrix.

Double-Ring Infiltrometer
An apparatus used to determine soil infiltration capacity by recording the drop in water level in an inner concentric cylinder while an outer ring prevents lateral water spread.
Watershed Water Balance Equation
The relationship describing the disposition of precipitation (P) within a watershed: P=ET+SS+D, where ET is evapotranspiration, SS is soil water storage, and D is discharge to streams and aquifers.
Potential Evapotranspiration (PET)
The vapor loss that would occur from a land area if the soil were continuously maintained at optimum moisture content, commonly estimated as 0.65 times the rate of evaporation from a Class A evaporation pan.
Water Deficit
The mathematical difference between potential evapotranspiration and actual evapotranspiration (PET−ET), serving as an index of plant water stress.
Transpiration Ratio
The mass of water transpired by a crop to produce 1kg of dry matter, typically ranging between 200kg and 500kg in humid regions and nearly double that in arid regions.
Hydraulic Redistribution
The passive movement of water through plant root networks from moist soil layers to dry soil layers, including hydraulic lift where deep tree roots elevate water into dry surface horizons.
Vadose Zone
The aerated, unsaturated soil and subsoil zone situated between the land surface and the regional groundwater table.
Capillary Fringe
The subsoil zone directly above the water table that is saturated or nearly saturated because of water drawn upward from groundwater by capillary forces.
Epiaquic
A soil moisture condition characterized by saturation in the upper horizons caused by a perched water table situated above an impermeable layer (e.g., a clay pan or fragipan), while underlying layers remain unsaturated.
Endoaquic
A soil moisture condition in which the entire soil profile is saturated from below by the regional groundwater table.
Perc Test (Percolation Test)
A standardized field procedure that measures the rate of water seepage from a test hole to determine soil suitability for a septic tank absorption field, with rates between 15mm/h and 150mm/h considered acceptable.
Blue Water
Freshwater stored in surface water bodies (such as rivers and lakes) and subsurface aquifers, which is accessible for withdrawal and diversion.
Green Water
Water stored in the unsaturated soil matrix as soil moisture and absorbed by plants for biomass production and evapotranspiration.
Gray Water
Mildly contaminated wastewater produced by municipal or industrial uses that can be safely recycled for nonpotable applications such as toilet flushing or landscape irrigation.
Black Water
Wastewater contaminated with human feces that is biological hazard and requires extensive treatment before reuse or environmental release.
Microirrigation
High-efficiency irrigation systems (including drip and trickle systems) that apply small quantities of water at high frequency directly to the plant root zone, achieving field water efficiencies of 80% to 90%.
Fertigation
The practice of injecting soluble plant nutrients directly into pressurized irrigation water (such as via center-pivot systems) for precise delivery to growing crops.

Silicon Tetrahedron
A four-sided structural building block of silicate clays consisting of a central silicon ion (Si4+) coordinated with four surrounding oxygen atoms (O2−).
Aluminum Octahedron
An eight-sided structural building block of silicate clays consisting of a central aluminum (Al3+) or magnesium (Mg2+) ion coordinated with six oxygen atoms or hydroxyl (OH−) groups.
Kaolinite
A 1:1-type aluminosilicate clay mineral consisting of alternating tetrahedral and octahedral sheets held rigidly together by hydrogen bonds, resulting in a nonexpanding lattice, lack of internal surface area, and a low CEC of 1 to 15cmolc/kg.
Smectite (Montmorillonite)
A 2:1-type expanding aluminosilicate clay mineral consisting of an octahedral sheet sandwiched between two tetrahedral sheets, characterized by wide interlayer spacing (1.0−2.0nm), high shrink-swell capacity, and a high CEC of 80 to 150cmolc/kg.
Fine-Grained Mica (Illite)
A 2:1-type nonexpanding clay mineral in which nonhydrated potassium (K+) ions fit tightly into tetrahedral cavities, locking adjacent layers together and limiting the CEC to 10 to 40cmolc/kg.
Vermiculite
A 2:1-type expandable clay mineral with extensive isomorphic substitution of Al3+ for Si4+ in the tetrahedral sheet, moderately restricted interlayer expansion (1.0−1.5nm) due to hydrated Mg2+ ions, and a very high CEC of 100 to 200cmolc/kg.
Chlorite
A 2:1:1 nonexpanding clay mineral comprising a 2:1 layer alternating with an octahedral-like magnesium-dominated hydroxide sheet in the interlayer, with an interlayer spacing of 1.41nm and CEC of 10 to 40cmolc/kg.
Gibbsite
An aluminum oxide/hydroxide mineral (Al(OH)3) formed in highly weathered soils (such as Oxisols) consisting of dioctahedral sheets bonded together by hydrogen bonds, carrying primarily pH-dependent charges.
Isomorphic Substitution
The replacement of one atom by another of similar size in a crystal sheet during mineral formation (e.g., Al3+ substituting for Si4+ in tetrahedra, or Mg2+ for Al3+ in octahedra), resulting in a permanent negative structural charge.
pH-Dependent Charge
Surface electrical charges developed on soil colloids (humus, 1:1 clays, and Fe/Al oxides) by the protonation or deprotonation of exposed edge hydroxyl (−OH), carboxyl (−COOH), and phenolic groups in response to changes in soil solution pH.
Point of Zero Charge (PZC)
The specific soil solution pH at which the total positive electrical charges on colloid surfaces exactly equal the total negative charges, yielding a net charge of zero.
Outer-Sphere Complex
A weak, easily reversible electrostatic association between a hydrated cation and a negatively charged colloid surface, where one or more intervening water molecules bridge the ion and the solid.
Inner-Sphere Complex
A direct, strong chemical bond formed between a specific ion (such as phosphate, H2PO4−) and a structural metal atom in the colloid without intervening water molecules, rendering the ion nonexchangeable.
Lyotropic Series (Selectivity Sequence)
The order of cation adsorption affinity on negatively charged soil colloids determined by ionic valence and hydrated radius: Al3+>Sr2+>Ca2+>Mg2+>Cs+>K+=NH4+>Na+>Li+.
Complementary Ion Effect
The principle that the vulnerability of an adsorbed cation to exchange and displacement depends on the strength of attraction of neighboring ions; loosely held neighbors (large oscillation zones) decrease displacement of a nutrient, while tightly held neighbors increase it.
Cation Exchange Capacity (CEC)
The total sum of exchangeable cations that a soil or colloid can absorb per unit mass, expressed in units of centimoles of positive charge per kilogram of dry soil (cmolc/kg).
Soil Partitioning Coefficient (Kd)
The ratio of chemical concentration sorbed to soil solids relative to its dissolved concentration in soil solution at equilibrium, where higher values indicate tighter sorption and less potential leaching loss.