1/31
Comprehensive practice flashcards covering water resources, groundwater storage, Darcy's Law, aquifer dynamics, water pollution, wastewater remediation, subsidence, and Karst erosion hazards.
What are the two major concerns regarding groundwater resources addressed in the lecture?
1) Groundwater usage problems, specifically land subsidence resulting from excessive groundwater withdrawal; and 2) Groundwater pollution and contamination.
In which three subsurface geological spaces does groundwater reside?
Groundwater resides within: 1) pores of soil, 2) spaces between grains of sediment or solid rock, and 3) narrow fractures in bedrock.
What provides secondary porosity in limestone, and how is it typically enlarged?
Fractures in limestone provide secondary porosity, and these fractures are enlarged over time through chemical dissolution.
What are the five large-scale water reservoirs identified in the global hydrologic system?
1) Atmosphere, 2) Land, 3) Ocean, 4) Snow and Ice, and 5) Subsurface/Groundwater.
What is the hydrologic cycle, and what four primary processes drive it?
The hydrologic cycle is the continuous movement and exchange of water among the oceans, land, and atmosphere. The four primary processes are precipitation, evaporation, transpiration, and condensation.
What is porosity, and how is it quantified?
Porosity is the total volume of empty space within a rock or sediment, expressed as a percentage (%). It determines how much groundwater can be stored and retained.
What is permeability?
Permeability is the degree to which pores are interconnected and represents the ability of a geological material to transmit fluid.
Based on the porosity data presented, how do clay and gravel compare in porosity, specific yield, and specific retention?
Clay has a high porosity (50%), low specific yield (2%), and high specific retention (48%). Gravel has a lower porosity (20%), high specific yield (19%), and very low specific retention (1%).
What is hydraulic head, and what governs the direction of groundwater movement?
Hydraulic head is a measure of the total potential energy of water at a specific point. Groundwater always moves down the energy gradient, from locations of higher hydraulic head to locations of lower hydraulic head.
Which two reference datums can be used to measure hydraulic head?
Hydraulic head can be measured relative to the local ground surface or relative to sea level.
What is Darcy's Law, and what does each variable in the equation Q=KAΔLΔh represent?
Darcy's Law quantitatively describes groundwater flow, stating that discharge is proportional to the hydraulic gradient. In the formula:
What two driving forces govern hydrologic flow paths, and what shape do these flow paths follow?
Groundwater flows in response to gravity (producing downward flow) and pressure (producing sideways and upward flow), resulting in a concave-up curved flow path from recharge to discharge areas.
What distinguishes the phreatic zone from the vadose zone?
The phreatic zone is the water-saturated zone below the water table where all pore spaces are filled with water. The vadose zone is the unsaturated zone above the water table where pore spaces contain both air and water.
What is the water table?
The water table is the boundary separating the saturated (phreatic) zone from the unsaturated (vadose) zone; it represents the upper surface limit of the saturated zone.
How do aquifers differ from aquitards?
Aquifers consist of permeable, porous rocks or sediments (such as sands and gravels) that transmit water easily. Aquitards are impermeable layers (such as clay) that do not transmit water easily and retard water movement.
What is an ordinary well, and what physical changes occur when it is heavily pumped?
An ordinary well penetrates below the water table into an unconfined aquifer and requires mechanical pumping. Pumping lowers the surrounding water table, producing a localized cone of depression.
What is an artesian well, and why does it not require pumping?
An artesian well penetrates into a confined aquifer where water is held under high hydrostatic pressure, allowing the water to rise upward on its own without pumping.
Under what conditions do hot springs form, and what is their typical water temperature range?
Hot springs develop in geothermal (magmatic) regions where groundwater is heated by cooling magma or hot igneous rock. Their water temperatures typically range from 30∘C to 104∘C.
What is a geyser, and what sequential physical process triggers an eruption?
A geyser is an intermittent eruption of hot water and steam from groundwater-filled chambers near hot igneous rock. The eruption process follows four steps: 1) water heats, 2) water expands, 3) water flashes into steam, and 4) steam erupts violently to the surface.
What caused the summer 2010 Gulf of Mexico oil spill, and what areas were heavily impacted?
The spill was caused by a major well blowout on the Deepwater Horizon drilling platform, polluting coastal wetlands and beaches with crude petroleum.
Which two major petroleum spills were highlighted as major historical water pollution events?
1) The Exxon Valdez oil spill in Alaska (1989), and 2) The Gulf of Mexico Deepwater Horizon oil spill (summer 2010).
What three main classes of toxic waste are identified as major water pollutants?
1) Organic chemicals (synthetic or natural carbon compounds, such as insecticides), 2) Heavy metals, and 3) Radioactive waste.
Which specific heavy metals are identified as dangerous water contaminants, and where do they typically deposit?
Lead (Pb), mercury (Hg), zinc (Zn), cadmium (Cd), silver, and arsenic. These metals commonly deposit in the bottoms of stream channels and occasionally in floodplains.
What are the common synthetic organic pollutants PCBs and Dioxins used for or derived from?
PCBs were used as liquid insulators in electrical transformers, while Dioxins are dangerous chemical by-products generated during herbicide production.
What three main systems are used for wastewater treatment across rural, municipal, and ecological settings?
1) Septic-tank sewage disposal systems (for rural residential areas), 2) Municipal water treatment plants (for towns and urban cities), and 3) Wetlands treatment sites.
How do wetland treatment sites purify nutrient-rich wastewater, and which climates are ideal for them?
Wastewater is routed to coastal wetlands where wetland plants absorb and utilize excess nutrients during their life cycles, reducing nutrient loads and improving effluent water quality. Warm-humid and hot-dry climates are ideal for this treatment.
What are four technical methods used to treat contaminated groundwater and vadose-zone water?
1) Extraction Wells (pumping out water for treatment by filtration, oxidation, air stripping, or biological processes) 2) Vapor Extraction (using vapor-extraction wells followed by treatment) 3) Bioremediation (injecting nutrients and oxygen to promote contaminant-degrading organisms) 4) Permeable Treatment Beds (passive contact beds installed along the flow path to neutralize plumes chemically, physically, or biologically)
What causes coastal saltwater intrusion into groundwater aquifers?
Excessive groundwater withdrawal (over-pumping) in coastal regions lowers the freshwater hydraulic head, allowing denser saltwater from the ocean to migrate inland into previously fresh aquifers.
What is the physical mechanism behind pore collapse and ground subsidence during over-pumping?
Pore water naturally exerts pressure that holds sediment grains apart. When over-pumping removes this water, the loose grains pack closer together, causing pores to collapse, permanently reducing porosity, and forming surface cracks, fissures, scarps, and ground subsidence.
What chemical reactions cause limestone dissolution and result in Karst topography?
Rainwater and groundwater absorb carbon dioxide (CO2) from the air and soil to form carbonic acid (H2CO3). Carbonic acid dissolves calcite in limestone (CaCO3) into soluble ions, carving out caverns, sinkholes, and Karst topography.
What three distinct terrain features characterize Karst topography?
1) Irregular, rocky surface terrain, 2) Sinkholes, and 3) Troughs (such as those observed on the Kras Plateau).
What specific catastrophic sinkhole collapse in Florida was highlighted as a major groundwater hazard?
The Winter Park sinkhole in central Florida, which formed abruptly and swallowed urban structures, including a drained municipal pool.