1/28
Looks like no tags are added yet.
Law of Conservation of Charge
Charge can be transferred from object to object, but it cannot be created or destroyed.
Conductor
A material through which electrons move easily (e.g., metals like copper, silver, aluminum).
Insulator
A material in which electrons are not able to move easily (e.g., rubber, glass, plastic, wood).
Conduction
The transfer of charge/electrons by direct contact between materials.
Induction
The rearrangement of electrons on a neutral object caused by a nearby charged object (without direct contact).
Grounding
Connecting an object to Earth using a conductor to safely drain excess charge.
Electroscope
A device used to detect the presence of electrical charge using metal leaves that repel when charged.
Voltage / Potential Difference [Unit & Symbol]
The push/force that causes electric charges to flow. Unit: Volts (V), Symbol: V
Electric Current [Unit & Symbol]
The rate at which electric charges flow past a point. Unit: Amperes or Amps (A), Symbol: I
Resistance [Unit & Symbol]
The tendency for a material to oppose or resist the flow of electrons. Unit: Ohms (Ω), Symbol: R
Electrical Energy [Unit & Symbol]
The energy delivered by electric current. Unit: Kilowatt-hours (kWh) or Joules (J), Symbol: E
Electrical Power [Unit & Symbol]
The rate at which electrical energy is converted to another form of energy. Unit: Watts (W) or Kilowatts (kW), Symbol: P
Direct Current (DC)
Electric current that flows in only one direction (e.g., powered by batteries).
Alternating Current (AC)
Electric current that reverses its direction in a regular pattern (e.g., household wall outlets).
Lightning Formation
Static charge builds up in clouds due to friction; induction causes charge separation on the ground; sudden discharge creates lightning.
Conductors vs. Insulators Resistance
Conductors have LOWER resistance; Insulators have HIGHER resistance.
3 Factors Increasing Wire Resistance
1. Longer wire length, 2. Thinner wire diameter, 3. Higher temperature.
Series Circuit
An electric circuit with only ONE path for current to flow. (If one bulb goes out, all go out; voltage drops across each resistor).
Parallel Circuit
An electric circuit with MULTIPLE branches/paths for current. (Adding more resistors/branches increases total current; voltage stays the same across branches).
Fuse
A small piece of metal that melts if the current becomes too high, opening the circuit to prevent fires.
Circuit Breaker
A switch that automatically opens a circuit if the current becomes dangerously high (can be reset).
Ground-Fault Circuit Interrupter (GFCI)
A safety outlet/breaker that detects current leaks to ground and instantly shuts off power (common near water/bathrooms/kitchens).
Ohm's Law Formula (Voltage)
V = I × R | Voltage (V) = Current (A) × Resistance (Ω)
Current Formula (from Ohm's Law)
I = V / R | Current (A) = Voltage (V) / Resistance (Ω)
Resistance Formula (from Ohm's Law)
R = V / I | Resistance (Ω) = Voltage (V) / Current (A)
Electrical Power Formula
P = I × V | Power (W or kW) = Current (A) × Voltage (V)
Electrical Power (using Resistance)
P = I² × R or P = V² / R
Electrical Energy Formula
E = P × t | Energy (kWh) = Power (kW) × Time (hours)
Cost of Electricity Formula
Cost = Energy (kWh) × Rate (Cost per kWh)