1/11
Looks like no tags are added yet.
What does theoretical yield mean?
The theoretical yield of a chemical reaction is the maximum mass of product that could be produced, assuming the reaction goes to completion with no loss of product
What are the steps of calculating theoretical yield?
1 - Use a balanced chemical equation to find the molar ratio between reactants and products
2 - Calculate the moles of the limiting reagent present
3 - Determine the mass of product that these moles of limiting reagent could produce, using the mole ratio
What is the actual yield?
The actual yield is the mass of product actually produced and collected from a reaction
Is the actual yield always higher or lower than the theoretical yield?
The actual yield is always lower than the theoretical yield.
What are the 5 factors that cause deviations in actual yields, causing them to be lower than theoretical yields?
1 - Incomplete reactions
2 - Waste
3 - Extraction
4 - Side reactions
5 - Hydration (reactions carried out in water only)
Factor 1 - Incomplete reactions: how does this result in deviations in actual yields?
Incomplete reactions can happen because the reaction is very slow and hasn’t been given enough time to happen.
The reaction is reversible and some of the products have turned back into reactants.
This reduces the percentage yield.
Factor 2 - Waste: how does this result in deviations in actual yields?
Some of the chemicals will remain stuck to the glassware and will be wasted.
This reduces the percentage yield.
Factor 3 - Extraction: how does this result in deviations in actual yields?
It might be difficult to fully separate the product from the reaction mixture.
This reduces the percentage yield.
Factor 4 - Side reactions: how does this result in deviations in actual yields?
Unexpected reactions (side reactions) can happen. This may mean that the intended product is not created.
This reduces the percentage yield.
Factor 5 - Hydration: how does this result in deviations in actual yields?
If a reaction is carried out in water, any extracted product may be 'wet'
This means that there is water in the extracted product.
Water is generally extremely difficult to fully remove from a product.
If a percentage yield is calculated to be over 100%, it is likely that your product is full of water.
What is the equation for calculating percentage yield?

What insights do percentage yields offer?
A yield that’s above 90% is seen as efficient and high-yielding
Lower yields suggest that the process needs optimization