1/18
Vocabulary practice flashcards covering rotary versus solid-state UPS systems, power quality anomalies, power conditioning devices, and IT earthing and cable segregation standards.
Uninterruptible Power Supply (UPS)
A device that provides backup power when the mains supply fails and conditions power quality for sensitive loads such as IT equipment.
Rotary UPS System
A mechanical UPS system using a motor-generator set and a flywheel (sometimes paired with a diesel engine) to store kinetic energy and bridge power gaps.
Solid State UPS System
An all-electronic UPS system consisting of a rectifier, battery bank, inverter, and static bypass switch that provides instant transfer with no moving parts except cooling fans.
Transient
A very short, high-voltage spike lasting <1 cycle caused by lightning, switching inductive loads, or faults, risking component damage and data corruption.
RFI / EMI
Radio Frequency or Electromagnetic Interference produced by motors, welders, and radio transmitters that causes data errors and communication failures.
Electrical Noise
Unwanted signals on a power supply, appearing either in normal mode (between live and neutral) or common mode (between live/neutral and earth).
Voltage Surge
A voltage increase exceeding 110% of nominal voltage lasting for >1 cycle, leading to overheating and insulation breakdown.
Voltage Sag / Brownout
A voltage drop to 80–90% of nominal voltage lasting for >1 cycle (termed a brownout when sustained over a long duration), causing system resets and data loss.
Blackout
A complete loss of electrical mains power, resulting in total equipment shutdown and data loss.
Metal Oxide Varistor (MOV)
A fast-acting component utilized inside surge suppressors to divert excess high voltage to earth during spike events.
Power Line Conditioner
A power conditioning device that utilizes transformers and filters to correct sags, surges, and electrical noise without offering battery backup during mains failure.
Off-line (Standby) UPS
A UPS topology where the load normally runs directly from mains and switches to battery and inverter power in 2–10ms upon mains failure or sag.
On-line (Double Conversion) UPS
A UPS topology where power continuously flows from mains through a rectifier to a DC bus and then through an inverter to the load, providing zero transfer time and total mains isolation.
Very Clean Wiring Category
Wiring dedicated to sensitive data circuits (such as Ethernet, fiber, RS232, and analog signals) that must be run separately, often in metal conduit or trunking.
Clean Wiring Category
Wiring carrying UPS outputs and conditioned power to IT loads; can be run alongside very clean cabling but must remain segregated from dirty cabling.
Dirty Wiring Category
Wiring circuits supplying mains, motors, lifts, fluorescent lighting, and welders that must be segregated from clean circuits by ≥300mm or a metallic partition.
Circuit Protective Conductor (CPC)
The safety earth conductor designed to carry electrical fault currents, which becomes electrically noisy during faults and must never be used as a communication signal reference.
Technical Earth Conductor (TEC)
A dedicated, quiet functional earth run directly from the main earth terminal and bonded at only one point to provide a noise-free signal reference for data systems.
Earth Loop
A condition occurring when equipment is grounded at two separate points with a potential difference between them, producing circulating 50Hz current that induces noise and data errors.