1/117
Looks like no tags are added yet.
net energy yield
total amount of useful energy available from a source minus energy needed to get it
ex) useful energy: 10 units
input: 9 units
yield: 1 unit
net energy ratio
ratio of useful energy to energy input
-the higher the ratio, the greater the gain.
ex) useful energy/input, 10/9 = 1.1
net energy loss
energy ratio is less than 1
nonrenewable energy
source of energy can’t be replaced
ex) nuclear power
fossil fuels
sources of energy that were fossilized millions of years ago and are no longer being made.
example: oil, coal, natural gas
renewable energy
source of energy that is replaceable.
example: solar (sun), wind, biomass.
pros to using oil
-high but decreasing net energy yield
- efficient distribution
cons to using oil
oil spills, drilling/shipping accidents, terrorism
other cons of using oil
dependence on international trade, air pollution
ANWR
refuge for wildlife in alaska, uses approximately 4-10 billion barrels of oil
oil shale/tar sand
crude oil trapped in rock and sand.
- low energy yield because of immense energy needed to retrieve it.
pros of oil shale
large potential supplies, easy transportation, efficient distribution
cons of oil shale
low yield of energy, severe land disruption and high water use
natural gas
methane (CH4) + other hydrocarbons
LNG
Liquified natural gas for safe transport
conventional natural gas
above oil deposits
- sometimes burned off as waste during drilling
unconventional natural gas
isolated, difficult to recover
- releases a large amount of methane and more greenhouse gases than coal.
hydraulic fracturing
1) well goes underground, injecting fracking fluid into fissures
2) fracking fluid pushes out natural gas from fissures and pumps into well
backflow
fracking fluid + leached materials from rock
options for disposal (hydraulic fracturing)
recycling (requires cleaning, expensive)
hazardous waste wells
pros of conventional natural gas
high energy yield, emits less CO2 than fossil fuels
cons of conventional natural gas
LNG has low energy yield
releases CO2 when burned
difficult/expensive to transport
progressive ranks of coal
peat, lignite, bituminous, anthracite
peat
partially decayed plant matter; converts to lignite under pressure and heat
lignite
low heat and sulfur content, becomes bituminous from heat and pressure
bituminous (soft coal)
high heat and sulfur content, used as fuel due to heat content, becomes anthracite from heat and pressure
anthracite
highly desirable because high heat and low sulfur content
environmental impact of underground mining
disruption of habitat, risk to miners, fires, air pollution
environmental impact of strip mining
loss of habitat, changes to topography, water pollution
what is released from burning coal
CO2, sulfur dioxide, ash, uranium, etc.
pros for coal
high yield, low cost when environmental costs aren’t included, ample supplies in many areas
cons for coal
severe land disturbance and water pollution, particle/mercury emission threatens human health, large co2 emission when burned
CO2 per pound of coal
2.5
carbon sequestration
capture carbon before it reaches the atmosphere
cleaning coal
variety of tech used to reduce environmental impact of coal
gasification
convert coal to syngas (co+h)
reduces CO2 when burned
cost of cleaning coal
adding clean coal tech doubles cost of electricity
estimated cost of cleaning all coal fired plants in U.S = $1 trillion
coal lifespan as a fossil fuel
114 years
gas lifespan
57.8
oil lifespan
50.7 years
fission power
large atomic nucleus is hit with neutron, causing it to release more neutrons.
this chain of atom splitting releases energy
boiling water reactor (bwr)
nuclear reactor where fission heats water, producing steam that turns the generator and starts electricity.
- older reactor type
pressurized water reactor (pwr)
PWRs keep water heated but don’t boil it while evaporating water in steam generator at the same time
condenser
condenses steam back to water
emergency cooling system
monitors coolant and injects more when necessary
control rods
controls energy output by absorbing neutrons
moderator
slows neutrons to maintain fission reaction
uranium 235
neutron source
fuel rods
contain uranium
neutron
subatomic particle
river water
source of coolant in reactor
cooling tower
cools steam to water
three mile island
2 PWRS that came online in 1978
three mile island incident
steam built up in TMI 2 while turbine and reactor were shut down, releasing coolant water that rose in temperatures of 3,000 F, caused partial core meltdown.
radiation output of three mile island
8-100 millirems of radiation was released.
people there got a year’s dose of radiation in a day
chernobyl background
experiment to see if cooling system could still work even if the reactor went into low power mode.
what happened at chernobyl
because too many control rods dropped too quickly, the safety system was disabled, and because too many control rods rose after it caused a power surge, leading to explosions
april 20, 1986
chernoyl radiation release
200 times the radiation released by bombs dropped on hiroshima and nagasaki
half life
the time taken for the radioactivity of a specified isotope to fall to half its original value
red forest
radioactive particles settled on trees
fukushima daiichi incident
category 9 earthquake hit the power plant, causing fuel to decay and generate heat continuously until explosions occurred.
march 11, 2011
exposure symptoms of radiation
cancer, mutation, birth defects, death
spent fuel pools
fuel pools are contained underwater in the facility to thermally cool them.
temporary (1-20 years)
dry cask
steel cylinder used for transportation and long term storage of radioactive waste
deep geological repository
permanent storage of radioactive waste; underwater/underground where there’s no seismic activity.
yuca mountain
proposed place in nevada for deep geological repository
reprocessing
uranium degrades to plutonium.
separation reduces radioactivity of residue and recycles fuels
3 methods by which power plants are decommissioned
immediate dismantling, safe enclosure, entombment
immediate dismantling
all equipment and structures are removed and decontaminated
removes facility from NRC regulation
safe enclosure
facility is maintained and monitored to allow for radioactive decay until it is eventually dismantled
ex) TMI
entombment
radioactive containment part of facility is encased in structurally sound material
allowed to decay to safe levels
ex) chernobyl
pros of nuclear energy
low environmental impact, emits 1/6 as much CO2 as coal, low risk of accidents in plant
cons of nuclear energy
very low energy yield, high cost, may produce harmful long lived radioactive waste, promotes spread of nuclear weapons
passive residential solar heating
heat collection for energy is built into the home, roofs and vents designed to prevent overheating
active residential solar heating
solar collectors capture heat energy
energy input required to run pumps for solar energy
pros of solar heating
net energy moderate to high
very low emissions of co2 and low land disturbances
cons of solar heating
need access to sun 60% of the time during daylight
high installation and maintenance costs for an active system
backup system for cloudy days
solar energy thermal collectors
concentrate solar energy for high heat
steam produced to turn turbines and generate electricity
pros of thermal collectors
no direct CO2 emission
moderate environmental impact
cons of thermal collectors
low net energy and high cost
needs back-up + storage system for cloudy days
high water use for cooling
photovoltaic cells (electricity)
photons hit a semiconductor that emits electrons, those electrons generate electricity
cost for photovoltaic cell
20k-100k for a typical home
panels can last 50 yrs
pros of photovoltaic cell
moderate energy gain, little to no direct co2 emission/pollution, easy to install and move
cons of photovoltaic cells
high cost for older systems but decreasing rapidly
solar power can disrupt desert ecosystem
hydroelectric
captures energy from falling water via turbines using rotating magnets to make electricity
pros of hydroelectrcity
low CO2 emission, low cost to electricity, moderate to high energy gain
cons of hydroelectricity
large land disturbance and displacement of people
high emission of methane
wind power
winds turn turbine to create electricity
pros of wind power
moderate to high net energy yield, widely available, low cost of electricity, easy to build
cons of wind power
needs backup or storage system when winds die down
can kill birds/bats if not properly designed and located
biomass
use of material from living organisms as an energy source
energy crops for biomass
trees that can be coppiced ex) poplars, maples.
perennial grass that’s native/hardy, example: bluestem, switchgrass
poor choices as energy crops
annual grass (must be planted every year.)
oil plants (intensive management)
solid biomass
wood, wood waste, charcoal
pros of biomass
widely accessible, no net Co2 gain if handled sustainabilly, plants can help restore degraded land.
cons of biomass
monoculture planting, deforestation, can increase CO2 emission if handled unsustainably
liquid/gas biofuels
plant material fermented to produce alcohol
oils from plants and algae, etc.
pros of liquid and gas biofuels
reduced co2 emission for some crops, high net energy yield for biodiesel but moderate for ethanol
cons of liquid biofuels
fuel and food crops compete for land
low net energy and higher CO emissions for corn ethanol
geothermal
uses earth interior as heat source