1/28
Vocabulary flashcards covering the fundamental concepts, definitions, formulas, and parameters of physical and mechanical properties of engineering materials.
Material Properties
Physical, chemical, or mechanical components of a specific product that determine its functionality, manufacturability, and performance limits.
Mechanical Properties
Properties that define the behavior of materials under external loads, measuring strength, lasting characteristics, and ability to resist deformation.
Strength
The mechanical capacity of a material to resist deformation load and withstand destruction under the action of external forces.
Elasticity
The ability of a material to resume its normal shape and come back to its original position after deformation when the applied load or stress is released.
Plasticity
The ability of a material to undergo permanent deformation without rupture once the elastic range has been exceeded.
Hardness
The ability of a material to resist scratching, abrasion, cutting, bending, or forced penetration.
Toughness
The property enabling a material to withstand shock or impact without breaking, representing a combination of strength and plasticity.
Brittleness
The tendency of a material to break or fracture under shock or impact rather than bend, marked by high compressive strength and low tensile strength.
Stiffness
The resistance of a material to elastic deformation or deflection when subjected to an applied load.
Ductility
The property of a material that enables it to undergo significant plastic deformation and be drawn out into a thin wire.
Malleability
The property of a material permitting it to be permanently deformed by hammering or rolling into sheets of other sizes and shapes.
Cohesion
The internal property of a solid body by virtue of which its particles resist being broken into fragments.
Impact Strength
The ability of a metal or material to resist suddenly applied dynamic loads without failure.
Fatigue
The progressive structural deterioration or fracturing of a material caused by repeated or cyclic straining actions.
Creep
The slow and progressive deformation of a material with time when subjected to a constant load or stress.
Stress (σ)
The internal resistance force per unit cross-sectional area that a material withstands, defined as σ=AF.
Strain (ε)
The fractional or percentage change in length of a material relative to its original length, defined as ε=LΔL.
Extrinsic Properties
Properties dependent on the geometry and size of a specific specimen, such as applied force (F) and elongation (ΔL=Lf−L0).
Intrinsic Properties
Inherent physical characteristics of a substance that do not depend on the dimensions of the sample, such as stress (σ) and strain (ε).
Engineering Stress (σeng) and Engineering Strain (εeng) Formulas
Engineering stress is defined as σeng=A0F and engineering strain is defined as εeng=L0ΔL=L0Lf−L0, both calculated using the initial dimensions.

Primary Modes of Applied Stress
The three standard mechanical loading configurations: compression (pressing inward), tension (pulling outward), and shear (sliding across adjacent planes).
Proportional Limit
The linear region on a stress-strain curve where stress is proportional to strain, obeying Hooke's Law with a constant ratio equal to Young's modulus.
Elastic Limit
The maximum stress up to which a material returns completely to its original dimensions when the applied load is fully removed.
Yield Point
The transition point beyond which a material ceases to respond elastically and begins permanent plastic deformation.
Ultimate Stress Point
The point representing the maximum engineering stress that a material can withstand before necking and failure occur.
Fracture Point
The terminal point on the stress-strain curve at which physical breaking or complete structural separation of the material occurs.
Young's Modulus (E)
A measure of material rigidity or resistance to elastic deformation, defined by the linear ratio E=εσ.
Pascal (Pa)
The SI unit of stress and pressure, equal to one newton of force distributed over an area of one square meter (1.0Pa=1.0N/m2).
Physical Property
An observable or measurable attribute of a material's physical state (such as density, melting point, or conductivity) that is independent of external loads or chemical reactions.