1/101
Looks like no tags are added yet.
QUESTION ONE: Where are both the intake and exhaust valves open at the same time
At the end of the exhaust stroke and the beginning of the intake stroke
QUESTION TWO: During the compression stroke, the intake valve closes, along with the upward movement of the piston inside the cylinder.
True
QUESTION THREE: Which of the following are NOT true regarding engine oil
Oil is a poor medium to transfer heat from the engine to the cooler
QUESTION FOUR: What is false regarding the viscosity of engine oil?
If an oil has too low a viscosity, it will wear the metal parts of an engine more quickly
Viscosity is the most important factor
In extreme cold temps, the oil will have a lower viscosity
QUESTION FIVE: At what temp is it recommended to preheat the engine regardless of the engine oil being used?
Answer: -6 degrees Celsius
QUESTION SIX: disadvantages of a float type carburetor are
They are prone to icing tendency;
Most prominent in diesel engines;
They are used for absurd maneuvering
They are hard to find parts
QUESTION SEVEN: Too rich a mixture….
Answer: All of the above
QUESTION EIGHT: Regarding the mixture control system,
The fuel mixture
All of the above
QUESTION NINE: Which of the following is true?
Rich mixtures are used at high power settings
Cruise
Lean is at high power
Lean is used at range power setting
QUESTION TEN: Assuming your equipment is supplied with only an RPM range
Answer: True
QUESTION ELEVEN: The four main purposes of engine oil
Cooling
Sealing
Lubricating
Flushing
Cleaning
QUESTION TWELVE: The formation of carterbater ice is most likely to happen in what conditions
-5 c outside temp
5c outside temp
20c outside temp
15c outside temp
High humanity
QUESTION THIRTEEN: Which aspect of the functioning of the carburetor affects intake air in the following ways
Intake air velocity increases
Intake air decreases in pressure
Intake air increases in temp
Intake air slows down in the carburetor
QUESTION FOURTEEN: The image pic shows the lubrication system
Dry sump - contained in the engine in a separate tank
Wet sump - contained in the engine in the system
Sump - contained in the engine
Reservoir - oil tank located somewhere else
QUESTION FIFTEEN: When an engine is new, there is a break-in time specified by the manufacturer?
Answer: True
QUESTION SIXTEEN: The type of oil used
mineral oil
Detergent oil
Synthetic oil
QUESTION SEVENTEEN: The colour of unleaded avgas
Blue
Red
Green
Purple
QUESTION EIGHTEEN: What is destination?
Answer: Inability of the fuel and mixture to burn slowly
QUESTION NINETEEN: The first indication to a pilot that carburetor ice has formed
Drop in rpm
Rise in rpm
Increase in cylinder head temp
Decrease indicated on outside
QUESTION TWENTY: Pilots are cautioned not to use carburetor heat on the ground or while taxiing
Answer: FOD (foreign object damage). It helps avoid contamination as it doesn't filter well.
QUESTION TWENTY-ONE: What is the purpose of the float located in the float chamber in the carburetor
Attached to a needle, which puts the right amount of fuel in the carburetor, depending on the position of the float
The float is attached to the mixture,
Float prevents the chamber from flooding the engine
Regulating the amount of fuel starting in the primer
QUESTION TWENTY-TWO: Destination with preignition
Answer: Premature ignition due to local Carbon hotspots on the cylinder
QUESTION TWENTY-THREE: A pilot is in cruise; Willow notices that the RPM drops and the engine runs rough. Willow turns on the carb heat, and the RPM drops more, and the engine runs rougher.
She should Turn the carb heat off Leave the carb heat on
Turn carb heat off the prepare, engine failure
Leave carb heat on and lean the mixture
Low wing aircraft will typically employ what type of fuel system?
Fuel pump