1/100
Looks like no tags are added yet.
coronal plane
palms facing forward NOT palms facing upward
dorsal
posterior
volar
front of hand/palm
flexion
bending of a joint, angle of the joint decreases and the limbs move closer together
extension
straightening of a joint, angle of the joint increases and limbs move away from eachother
abduction
movement toward the midline
abduction
movement away from the midline
pronation
palms face down
supination
palms face up
dorsiflexion
hand or foot bends dorsally towards it upper surface
plantar flexion
top of foot moves away from your leg (pointing your toe)
hinge joint
flexion and extension
ex: elbow, knee, finger
saddle joint
flexion, extension, abduction, adductions
ex: thumb
condyloid joint
flexion, extension, circular motion
ex: wrist
ball and socket joint
all movements on any axis
ex: hip, shoulder
epiphysis
rounded end of long bone covered in cartiliage
metaphysis
narrow portion of long bone between epiphysis and the disaphysis
diaphysis
shaft of long bone
cortical bone
hard dense bone
cancellous bone
spongy bone
superior
describes a position above or higher than another body part
inferior
describes a position below or lower than another part of the body
medial
describes the middle or direction toward the middle of the body or towards the midline
lateral
describes the side or direction toward the side of the body away from the midline
proximal
closest to or nearest the point of origin of a structure or limb
distal
away from or the farthest from the attachment point of the structure or limb
coronal plane
divides the body into left and right sections
sagittal plane
divides the body into left and right segments
transverse plane
divides the body into upper and lower sections
agonist muscle
muscle that contracts during flexion or extension
antagonist muscle
muscle that relaxes or lengthens during flexion or extension
ligaments
tissue that connected two bones together in a joint
tendons
attaches muscle to bone
synovial membrane
layer of connective tissue that lines the cavities of joints, tendons, fluid filled sacs between tendons and bones
transverse fracture
fracture line is perpendicular to the shaft of bone
oblique fracture
fracture line is on an angle relative to the shaft
butterfly fracture
two oblique fracture lines that create a wedge shaped fragment
segmental fracture
fracture with at least 2 fracture lines that isolate a segment of bone
simple fracture
fracture that consists of 2 pieces and is closed
comminuted fracture
fracture consists of multiple fragments often a result of a high energy injury
non displaced fracture
bone fractures either partially or completely through but does not move, bone maintains proper alignment
displaced fracture
fracture involves 2 or more parts and shifts so that the 2 ends of bone are no longer aligned
distal bone or segment dictates the displacement direction
closed fracture
fracture but no skin break or open wound
open fracture
fracture involving a skin break or open wound
extraarticular fracture
does not involve the joint surface
intraarticular fracture
involved the joint surface
shortened deformity
proximal migration of the distal fracture component results in shortening of overall bone length, caused by contraction in the soft tissue no longer under tension
angulated deformity
displacement where the normal axis of the bone has been altered such that the distal portion of the bone points off in a different direction
rotated deformity
displacement where there has been a rotation of the distal fracture fragment in relation to the proximal portion
varus deformity
distal fragment is angled toward the midline
valgus deformity
distal fragment is angled away from the midline
flexion deformity
occurs when the displacement of the proximal and distal fragments shows a flexed position
extension deformity
occurs when the displacement of the proximal and distal fragments show and extended position
primary bone healing
absolute stability, zero motion with rigid fixation
anatomic reduction
compression at the fracture site
heals with no callus
achieved through lag screws
secondary bone healing
relative stability, micromotion at the fracture site
does not require an anatomic reduction
preserves biology at fracture site
heals with visible callus
often used in metaphyseal or diaphyseal fractures
IM nails, bridge plating, or non op methods such as splint/cast
casting/splinting
simple fractures and sprains
requires joint immobilization
load bearing constructs
external fixation
preserves soft tissue
temporary fixation
often used for extensive soft tissue injury or unstable patients
load bearing construct
relative stability
IM nails
preserves soft tissue
helps maintain length, alignment, and rotation
can be placed in static or dynamic modes
ideal for diaphyseal and metaphyseal fractures
provides relative stability (uses secondary healing)
load sharing construct
often associated with earlier weight bearing
plates and screws
ORIF: open reduction internal fixation
ideal for articular fractures
load bearing construct
position screws
maintain alignment
screw core diameter
equal to the diameter of the standard drill bit used
thread diameter
width of the screws threaded shaft measured at the outermost points of the threads
equal to the names size of the screw or diameter of the over drill used for lagging
lag screws
compress bone fragments
stryker plating systems
torx head designs
stryker nailing systems
hex head designs
cortical screws
non locking screw
smaller thread/core diameter ratio
must be bicortical
self tapping
cancellous screw
non locking screw
larger thread/core diameter ratio
must be bicortical
multiple thread length options
cannulated screw
non locking screw
often used through and around the articular surface
helps maintain reduction during insertion
partial thread and full thread options
headed and headless options
self drilling, self tapping options
locking screws
thread on screw head thread into plate holes to create a fixed angle construct