PPE FLASH CARD

0.0(0)
Studied by 0 people
call kaiCall Kai
learnLearn
examPractice Test
spaced repetitionSpaced Repetition
heart puzzleMatch
flashcardsFlashcards
GameKnowt Play
Card Sorting

1/14

encourage image

There's no tags or description

Looks like no tags are added yet.

15 Terms

1
New cards

Effect on steam pipe heat conduction when the two insulating layers are interchanged

Increases. Swapping the layers lowers the total thermal resistance of the composite insulation, so heat conduction through the pipe rises.

2
New cards

HFC refrigerant R-134a is a long-term replacement for which refrigerant?

R-12, a CFC refrigerant that R-134a was developed to replace as a non-ozone-depleting alternative with similar properties.

3
New cards

Part of a combined cycle plant that usually governs ramp rate

HRSG (Heat Recovery Steam Generator), because its thick metal components and large steam and water inventory slow its thermal response.

4
New cards

Heat exchanger with concentric tubes and one fluid inside and one outside

Double-pipe heat exchanger, which has one fluid in the inner pipe and another in the annular space between the concentric pipes.

5
New cards

ASME code that covers welding qualifications for piping

ASME Section IX, which governs the qualification of welding procedures and welders.

6
New cards

Component that regulates steam flow to the turbine

Governor valve, which modulates the quantity of steam entering the turbine to control power output or speed.

7
New cards

Desirable properties of a refrigerant

Large latent heat of vaporization and low operating pressures, which reduce circulation rates, compressor size, material requirements, and energy use.

8
New cards

Dimensionless number that indicates the significance of internal conduction resistance

Biot number, the ratio of conductive thermal resistance inside a solid to convective thermal resistance at its surface.

9
New cards

Variable load in a power plant

Fluctuation in electrical demand over time, meaning the continuous changes in electricity drawn from the grid that power plants must follow.

10
New cards

Primary purpose of a liquid-to-suction heat exchanger in a vapor compression system

Subcool the liquid refrigerant leaving the condenser, reducing flash gas and increasing the net refrigeration effect.

11
New cards

Dimensionless number representing the ratio of buoyancy to viscous forces

Grashof number, the dimensionless group comparing buoyancy forces to viscous forces in natural convection.

12
New cards

Fan type best for handling large volumes of clean air at low pressure

Propeller fan, which moves large volumes of air efficiently against low resistance, ideal for ventilation and cooling with minimal ducting.

13
New cards

Effect of increasing compression ratio in SI engines

Efficiency increases. For an Otto cycle, η=1−1rγ−1\eta = 1 - \frac{1}{r^{\gamma-1}}, so higher compression ratio r raises thermal efficiency until knock or material limits apply.

14
New cards

Law governing convection heat transfer

Newton's law of cooling, which states that convective heat transfer is Q=hAΔTQ = hA\Delta T.

15
New cards

Factor that increases when duct length and roughness increase

Pressure loss, which rises with longer duct length and greater roughness due to increased friction, as described by the Darcy-Weisbach equation.