1/24
This set of vocabulary flashcards covers the fundamental concepts of electric circuits, including Ohm's Law, power calculations, circuit configurations, and components like diodes and capacitors based on Lecture 23.
Voltage
A measure of electric potential or potential difference between two points in a circuit, symbolized by the capital letter V and measured in units of volts (V).
Battery
A source of constant voltage produced through chemical means to separate positive and negative charges; common household examples like AA, AAA, and D-cell batteries output 1.5V.
Potential Difference
Another term for voltage, describing the difference in electric potential measured between two points in a circuit.
Resistance
The property of a material that impedes the flow of electrons, symbolized by the capital letter R and measured in units of ohms (represented by the Greek letter Ω).
Resistivity
An inherent property of a material that relates to its resistance, symbolized by the lowercase Greek letter ρ and measured in units of ohm-meter.
Resistivity of Copper
A value approximately equal to 1.7×10−8ohm−meters at room temperature.
Resistance Equation
The formula used to determine resistance based on material properties: R=Aρ⋅L, where L is length and A is cross-sectional area.
Current
The flow of electric charge through a circuit, symbolized by the capital letter I and measured in amps (A).
Amp (Ampere)
The unit for current, where 1amp is equal to 1coulomb of charge moving past a given point every second (1C/s).
Ohm’s Law
The fundamental relationship in electronics stating that voltage equals current times resistance, expressed as V=I⋅R.
Power
The rate at which energy is consumed in a circuit element, symbolized by the capital letter P and measured in units of watts (W).
Power Equation
In an electric circuit, power is calculated as the product of current and voltage: P=I⋅V.
Conservation of Power
The principle stating that all of the power consumed in a circuit is equal to all of the power generated in a circuit.
Kilowatt-hour
A unit of energy used in electric bills, representing power multiplied by time (one thousand watts consumed over the duration of one hour).
Series Circuit
A configuration where all circuit elements are connected in the same loop, meaning they all experience the same amount of current.
Total Resistance in Series
The sum of the individual resistors in the circuit, resulting in a total resistance greater than any of the individual resistors.
Parallel Circuit
A configuration where each resistor is connected in its own loop end-to-end, meaning each element experiences the same amount of voltage.
Open Circuit
A circuit where there is no complete path for current to flow, causing electrons to stop moving and components to cease operation.
Short Circuit
A very low resistance path (such as a wire) that bypasses other components, causing extremely high current and heating that can melt circuit components.
Direct Current (DC)
A type of electrical flow where the voltage and current stay constant over time, commonly produced by batteries.
Alternating Current (AC)
Electric current that changes over time, usually oscillating in a sinusoidal wave pattern; in the United States, it oscillates at 60Hz with an average of 120V.
Oscilloscope
A device used to record and graph how voltage changes with respect to time.
Diode
A circuit element that acts like a one-way valve, allowing current to flow in only one direction.
Rectifier
A circuit involving diodes that only allows current to flow in one direction, effectively blocking negative voltages from an AC signal.
Capacitor
A device used to smooth out oscillations in output voltage to help obtain a smooth DC voltage signal.