1/46
Vocabulary practice flashcards covering sitework terminology, soil tests, Atterberg limits, geosynthetics, termite proofing methods, and road paving materials from Building Technology 1.
AASHTO
American Association of State Highway and Transportation Officials.
ANSI
American Nurserymen's Specifications Institute.
ASTM
American Society for Testing Materials.
DPWH
Dept. of Public Works and Highways (Phil Gov.).
USCS
Unified Soil Classification System.
AASHTO Soil Classification System
A classification system that evaluates inorganic soils for suitability as subgrade materials in terms of drainage and bearing capacity.
Boulders (AASHTO)
Soil particle sizes above 75mm.
Gravel (AASHTO)
Soil particle sizes ranging from 75mm to the No.10 sieve.
Coarse Sand (AASHTO)
Soil particle sizes ranging from the No.10 sieve to the No.40 sieve.
Fine Sand (AASHTO)
Soil particle sizes ranging from the No.40 sieve to the No.200 sieve.
Silt-Clay Particles (AASHTO)
Soil particles passing through the No.200 sieve.
Atterberg Limits
Standard soil tests performed on fraction passing the No.40 sieve to measure consistency and moisture thresholds (Liquid Limit, Plastic Limit, and Plasticity Index).
Liquid Limit (LL)
The moisture content at which soil changes from liquid state to plastic state, measured when soil in a shallow dish flows to close a 12.5mm groove after 25 drops from 1cm.
Plastic Limit (PL)
The water content at which a silt or clay material will just begin to crumble when rolled into a thread approximately 3.2mm (1/8inch) in diameter.
Plasticity Index (PI)
The numerical difference between Liquid Limit and Plastic Limit (LL−PL=PI), representing the moisture content range over which sediment behaves plastically.
Fill Materials
Soil, crushed stone, and sand used to raise an existing grade or as a man-made deposit under footings, pavers, or concrete slabs on grade.
Granular Fill or Filters
Soil materials with a sand equivalent of not less than 50% used to prevent movement of fine particles out of soils during seepage, conforming to ASTM C 33, size 67.
Borrow Fill
Laboratory-approved pit-run gravel, disintegrated granite, sand, shale, cinders, or similar materials with not more than 35% fraction passing the No. 200 sieve.
Base Course Materials
Hard durable stone fragments and sand/mineral filler free from vegetable matter and clay lumps, conforming to AASHO METHODS T-11 and T-26 grading requirements.
Banda y Banda
A local fill material designation used in construction earthworks.
Escombro
A local borrow fill material priced at P5,000 per 15 to 16cum.
Escombro - Bulik
A type of local escombro borrow material specifically used for rip-rap installation.
Riprap (Rock Lining)
A constructed layer or facing of large aggregate (2inches to 42inches in diameter) placed to prevent erosion, scour, or sloughing of embankments.

Gabion System
Wire-enclosed riprap consisting of mats or baskets fabricated from wire mesh, filled with small riprap, and anchored to a slope.

Geosynthetics
Construction materials made of synthetic components designed for use with or within earth materials.
Geotextiles
Woven or nonwoven polymeric fabrics (such as polyester or polypropylene) used for separation, filtration, reinforcement, and in-plane drainage.
Geotextile Reinforcement
Geotextile application where fabric strength is added to low load-bearing soil to increase overall design strength and reduce sub-base and base course thickness.

Geotextile Separation
Geotextile application where fabric is placed between dissimilar materials to prevent intermixing or migration of one material into another.

Geotextile Filtration
Geotextile function that allows water passage while preventing the movement of fine soil particles through seepage channels.
Sediment Control Geotextiles
Geotextiles used exclusively in silt fence applications to intercept and filter runoff sediment.
In-Plane Drainage Geotextiles
Thick-needled nonwoven geotextiles engineered with sufficient in-plane flow capacity to serve as liquid conduits.
Geomembranes
Continuous, impermeable polymeric sheets (such as HDPE, PVC, or EPDM) used as fluid barriers in ground and waterproofing applications.
Geocomposites
Combinations of geosynthetic components, typically sheet or edge drains formed by a prefabricated drainage core bonded with a geotextile filter.

Geonet
A geosynthetic formed by continuous extrusion of polymeric ribs that create void spaces providing high in-plane fluid flow capacity.
Geocells
Three-dimensional prefabricated polymeric structures 100mm to 200mm (4 to 8inches) high that open into a cellular matrix to stabilize subgrades and slopes.

Termite Resistant Sand
A physical termite barrier consisting of a layer of uniform sand particles large enough to prevent termite tunneling and passage.
Termite Mesh
A fine stainless steel mesh physical barrier designed to block termites from passing through concrete slab joints and pipe penetrations.
Termiticide
A chemical solution applied to soil or foundation structures to kill, repel, or prevent subterranean termites from accessing wood.
Vertical Chemical Barrier
Chemical termite treatment created by applying 16liters (4gallons) of termiticide per 3linear meters via rodding or trenching around foundations and plumbing.
Horizontal Chemical Barrier
Chemical termite barrier created by spraying 4liters (1gallon) of termiticide per 3square meters across sub-grade areas prior to pouring concrete slabs.
Colony Elimination (Bait) System
A termite proofing method that uses bait stations containing Hexaflumuron to destroy termite worker populations and eliminate the queen.

Hexaflumuron
A slow-acting insect-growth regulator (IGR) used inside termite bait systems to eliminate foraging workers and colony queens.
Choker Aggregate
A filter course of fine aggregate laid over coarse road base material to create a stable foundation for surface pavement.
Hot Mix Asphalt
A dark cementitious paving material composed of bitumen mixed with graded aggregates, placed and compacted while hot over a prepared base.
Cold Mix Asphalt
Asphaltic concrete prepared with slow-curing asphalt laid without heat, producing a paving layer less firm than hot-mix asphalt.
Asphaltic Macadam
Pavement formed by compacting layers of crushed stone or gravel and binding the top layer with asphalt to seal against water penetration.
Asphalt Overlay
One or more layers of new asphalt aggregate mixture applied over existing pavement to correct surface levels and contours.