1/22
Comprehensive vocabulary flashcards covering transistor operation, amplification, potential dividers, and sensor-based switching circuits.
Transistor
An electronic component used to amplify electric current or function as an electronic switch.
Emitter (E)
The terminal of a transistor that supplies charge carriers to the collector.
Base (B)
A thin middle layer of a transistor that controls the flow of charge carriers from the emitter to the collector.
Collector (C)
The terminal of a transistor that receives charge carriers from the emitter.
NPN transistor
A transistor consisting of two n-type semiconductor regions separated by a p-type semiconductor region.
PNP transistor
A transistor consisting of two p-type semiconductor regions separated by an n-type semiconductor region.
Transistor symbol arrow
The feature indicating the direction of conventional current through the emitter, pointing outwards for an NPN transistor and inwards for a PNP transistor.
Base current (IB)
The small current flowing into the base terminal of a transistor.
Collector current (IC)
The current flowing through the collector circuit.
Emitter current (IE)
The current flowing through the emitter terminal.
Base resistor
A resistor connected to the base circuit to limit the base current and prevent excessive current from damaging the transistor.
Current amplifier
An electronic circuit that increases the magnitude of an input current.
Current amplification factor (β)
The ratio of collector current to base current, defined by β=IBIC.
Minimum base-emitter voltage (silicon)
Approximately 0.7V, required to turn on a silicon transistor.
Minimum base-emitter voltage (germanium)
Approximately 0.3V, required to turn on a germanium transistor.
Potential divider
A circuit consisting of two resistors connected in series to divide the supply voltage.
Potential divider formula
The formula used to calculate output voltage across resistor R2 when R1 is connected to the supply's positive side: Vout=R1+R2R2Vin.
Automatic transistor switch
An arrangement where the transistor switches the collector circuit on or off depending on the base current (switches ON with sufficient base current and OFF without sufficient base current).
Light-dependent resistor (LDR)
A resistor whose resistance changes according to the intensity of light falling on it, increasing as light intensity decreases and decreasing as light intensity increases.
Automatic street lights
A practical application of a light-controlled transistor switch.
Thermistor
A resistor whose resistance changes according to its surrounding temperature.
NTC thermistor
A thermistor whose resistance decreases when temperature increases and increases when temperature decreases.
Temperature-controlled alarm system
A practical application of a heat-controlled transistor switch.