1/84
Looks like no tags are added yet.
74.3°C
Heat transfer across a 4.5" wall is 480 W/m2. If the cold surface is 32°C and k = 0.75 Btu/hr-ft-°F, find hot surface temperature.
0.0234 W/m-°C
Determine the thermal conductivity of a material that is used a 4 m2 test panel, 25 mm thick with a temperature difference of 20°F between surfaces. During the 4 hours of test period, the heat transmitted is 600 KJ.
327
A counterflow heat exchanger is designed to cool 0.65 kg/sec of oil with specific heat Cp = 3.4 KJ/kg-K from 150°C to 70°C. Water for cooling, Cp = 4.18 KJ/kg-K is available at 20°C and flow rate of 0.6 kg/sec. Calculate the length of a 3.5 cm inside diameter tubing in meters. The overall coefficient of heat transfer is 90 W/m2K.
4.5 bar
The service pump in a water supply system maintains a net static head lift of 5 m at the delivery tank through a 4 km long pipe. Minor losses are neglected. The pipe diameter is 0.2 m, and friction factor is 0.01. If water velocity is 2 m/s, determine the approximate pressure developed by the pump.
4200
5. The air contained in a room loses heat to the surroundings at a rate of 50 KJ/min while work is supplied to the room by computer, TV, and lights at a rate of 1.5 KW. What is the net amount of energy change in KJ of air in the room during a 30-minute period?
A) 0.36
B) 70
C) 660
D) 4200
125°C
A thermocouple produces an emf of 8 mV at 200°C and 2 mV at 50°C. Assuming linear behavior, determine the temperature corresponding to an emf reading of 5 mV.
483
Castor oil at 38°C flows over a wide heated plate 6 m long at 0.06 m/s. For a surface temperature of 93°C, thermal conductivity of 0.213 W/m-K, and average heat transfer coefficient of 17.16 W/m2-K, determine the average Nusselt number.
6,000
Castor oil at 38°C flows over a wide 6 m long heated plate at 0.06 m/s. If the kinematic viscosity is 6.0 x 10^-5 m2/s, determine the Reynolds number at the end of the plate.
0.386
The total incident radiant energy on a body which partially reflects, absorbs, and transmits radiation is 2200 W/m2. If 450 W/m2 is reflected and 900 W/m2 is absorbed, determine the transmissivity of the body.
-12.5%
10. The friction factor is overestimated by +25% in using the Darcy-Weisbach equation. Determine the resulting percentage error in discharge.
A) +25%
B) -18.25%
C) -12.5%
D) +12.5%
2.756
Two pipelines of equal length having diameters of 15 cm and 10 cm are connected in parallel between two reservoirs. If the friction factor is the same and the head difference between reservoirs is 3 m, determine the ratio of discharge through the larger pipe to that through the smaller pipe.
No listed option; approximately 1,287 W/m2.
12. For a blackbody maintained at 115°C, determine the total emissive power.
A) 0.992 W/m2
B) 1.287 W/m2
C) 6,523 W/m2
D) 9.92 W/m2
5.83 ohms
A strain gage installed on a 6-inch metallic rod has a gage factor of 2.0. When subjected to tensile force, the rod elongates to 6.5 inches. If the initial resistance is 5 ohms, determine the final resistance of the strain gage.
0.16 g/m3
An electrostatic precipitator removes 96% of dust particles from a flue gas stream containing 4 g/m3 of particulates. Determine the outlet dust concentration.
1
A pipe is connected in series to another pipe whose diameter is twice, and length is 32 times that of the first pipe. Determine the ratio of frictional head loss in the first pipe to that in the second pipe, assuming both pipes have the same friction factor.
1.74 x 10^-4 m2/s
A lubricating oil has absolute viscosity of 0.16 N-s/m2 and density of 920 kg/m3. Determine the kinematic viscosity.
42.8%
A pipeline connecting two reservoirs has its diameter reduced by 20% because of deposition of chemicals. For a given head difference and unchanged friction factor, determine the reduction in discharge.
33.11 Kw
What is the radiant energy leaving a 30-mm diameter sphere at 1200 K to surrounding air at 300 K assuming all surfaces behave as blackbodies?
0.005 ohm/°C
A Resistance Temperature Detector (RTD) has resistances of 10 ohms at 20°C and 15 ohms at 120°C. Determine the temperature coefficient of resistance.
59.8 mm
A 20 cm diameter and 500 m long pipe having friction factor f = 0.025 discharges water from a constant-head reservoir through a nozzle to atmosphere. Neglecting all losses except pipe friction. Determine the approximate jet diameter for maximum power transmission.
0.0812
A 40 mm diameter and 2 m long straight pipe carries steady water flow at 3 liters per minute. The viscosity of water is 1.02 centipoise. Determine the approximate wall shear stress in dyne/cm2.
0.21 m/s
Oil having specific gravity 0.8 and dynamic viscosity of 8 x 10^-3 Ns/m2 flows through a smooth pipe of 100 mm diameter with Reynolds number equal to 2100. Determine the average velocity in the pipe.
70.33 kW
The hot combustible gases of a furnace are separated from the ambient air and its surrounding, which are 29°C, by a brick wall 130 mm thick. The brick has a thermal conductivity of 1.23 W/m-K and a surface emissivity of 0.81. At steady state conditions the outer surface temperature is 130°C. Air surface film conductance is 15 W/m2-K. What is the total heat transmitted for 30 square meter area?
985.02 W
A 6 m square wall of a room has a surface temperature of 40°C. The wall thickness is 20 cm, has a thermal conductivity of 0.07 W/m-K, and air film conductance is 15 W/m2-K. If ambient air temperature is 20°C, find the heat loss through the walls.
34.44°C
A wall with a thermal conductivity of 0.30 W/m-K is maintained at 40°C. The heat flow through the wall is 250 W, the wall surface area is 1.5 m2 and its thickness is 1 cm. Determine the temperature of the other surface.
45.87 m
The equivalent head of a 30 m/s velocity of fluid is
1,714
What is the Reynolds number of flow in a smooth 1.0-cm interior diameter and 18-m long tubing when 25°C benzene having a kinematic viscosity of 7 x 10^-7 m2/s flows at an average velocity of 0.12 m/s?
20 Hz
A temperature monitoring system collects data at 10 Hz. Determine the minimum sampling frequency required to accurately reconstruct the signal.
0.5 V
An analog signal has a low voltage range of 9.5 V and a high voltage range of 17.5 V. If the A/D converter has 4 conversion bits, determine the voltage resolution.
360 N/m2
A lubricating oil has a dynamic viscosity of 0.18 N-s/m2 and is used in a bearing where the oil film thickness is 1.5 mm. If the sliding velocity is 3 m/s, determine the shear stress developed in the lubricant.
Globe valve
Which type of valve is best for throttling steam flow?
Prevent oxidation
What is the purpose of adding antioxidants to lubricating oil?
Spring support
Which support type allows vertical movement but restrains horizontal motion?
Check valve
Which device prevents reverse flow in piping?
Globe valve
Which valve provides tight shutoff in steam lines?
ASME Section IX
Which ASME code covers welding qualifications for piping?
Ball valve
Which valve is quick-operating and quarter-turn?
Air vent valve
Which piping accessory removes air pockets from water lines?
Hoop stress
Which type of stress is caused by internal pressure in pipes?
API 570
Which piping code governs maintenance of in-service piping?
Standard signal range
What is the reason for using a 3-15 psi range in pneumatic control systems?
Calorimetric principle
The working principle of a pyroelectric sensor is mostly based on:
Transient responses are obtained using Fourier transforms
Which of the following statements is false?
Temperature
What is the most important control variable in a data center?
Thermocouple
What device is commonly used to measure turbine inlet temperature?
Three-element control
Which type of control loop is used in boiler drum level control?
ISA S5.1
Which standard is followed for instrumentation symbols in P&IDs?
Resistance changes with temperature
Which sensor principle is used in RTD's?
AND/OR logic
Which logic system us used in interlocks for power plant safety?
Pitot tube
What device is installed in boiler flue gas ducts to measure flow?
DCS
Which control system supervises plant-wide operations?
Voltmeter
Which device monitors generator output voltage?
Dirt contamination
What causes an increase of silicon in lubricants?
Hydrodynamic lubrication
What type of lubricant occurs when the lubricant film completely separates the moving surfaces?
Cleveland open cup test
Which test is used to determine oil flash and fire point?
Amonton's Law
Which law relates frictional force to normal load in boundary lubrication?
Filtration
Which method prevents lubricant contamination by particles?
Demulsibility
What parameter indicates lubricating oil's ability to separate contaminants?
Graphite
Which lubricant is commonly used in high-temperature furnace chain drives?
Splash lubrication
Which lubrication system uses a rotating component to splash oil onto parts?
Oil pump
Which device supplies oil under pressure in centralized lubrication systems?
Detergent additive
Which additive neutralizes acidic by-products in lubricating oils?
Radiation
What mode of heat transfer requires no medium?
Newton's law of cooling
Which law governs convection heat transfer?
Natural convection
Which convection occurs due to buoyancy forces from density differences?
Emissivity
Which property defines a surface's deviation from a blackbody?
Prandtl number
Which dimensionless number represents ratio of momentum to thermal diffusivity?
Nusselt number
Which number correlates convection heat transfer coefficient?
Biot number
Which number indicates significance of internal conduction resistance?
Lumped system assumption is valid
What does a small Biot number (Bi << 1) imply?
Planck's law
Which law gives monochromatic emissive power of a blackbody?
Grashof number
Which number represents ratio of buoyancy to viscous forces?
Churchill-Chu correlation
Which correlation is used for natural convection along vertical plates?
Fluid Velocity
What factor directly affects convective heat transfer?
Increases
What happens to the convection heat transfer coefficient when air velocity increases?
RA 8749
Which law in the Philippines is known as the Clean Air Act?
RA 9275
Which law is known as the Clean Water Act of the Philippines?
Smoke opacity
Which pollutant is measured by Ringelmann chart?
>0.5
What is the ideal BOD5/COD ratio for biodegradable wastewater?
Air pollution emissions
Which is the main disadvantage of incineration of solid waste?
Piping and Instrumentation Drawing
What does the acronym PID stand for?
wet scrubber
Which control device removes fine mist and droplets from gases?
Certificate of Non-Coverage (CNC)
What document is issued by the DENR-EMB to certify that a proposed project is not covered by the Environmental Impact Statement (EIS) System and therefore does not need an Environmental Compliance Certificate (ECC)?
Certificate of Conformity
Under the Philippine Clean Air Act (RA 8749), what certification is granted by the DENR to vehicle manufacturers, assemblers, or importers as proof that a new motor vehicle or vehicle type satisfies the prescribed emission standards?
PHP 100,000.00
According to RA 8749 or the Philippine Clean Air Act, the Pollution Adjudication Board (PAB) may impose a penalty of up to ________________ per day for violations of pollution or air quality standards until compliance is attained.