1/10
Looks like no tags are added yet.
steps for preparing microscope slide
Use a sharp scalpel or blade to cut a very thin slice of the specimen so that light can pass through
Place a small drop of water on slide -suspend the specimen with pipette
use tweezers place thin section ontop water
add stain to highlight objects in cell
add coverslip at an angle so no air bubbles which obstruct view of specimen
using microscope steps
Place the slide containing a tissue specimen on the microscope stage
Turn the objective lens so that the lowest power lens is in use
Use the coarse focus wheel to lower the lens as far down towards the stage as possible
Adjust the fine focus to raise the lens until the specimen is in focus
If the specimen is too small, turn the objective lens to the next-highest power and refocus
Repeat with the highest power objective lens if necessary
biological drawings
Use plain white paper and a sharp HB pencil.
Draw large, accurately proportioned diagrams.
Use clear, continuous single lines without sketching or overlapping.
Do not shade or colour; use stippling only if necessary.
Use a ruler for straight label lines on one side only, with no arrowheads.
Include a descriptive title and magnification or scale bar.
investigating mitosis practical steps
1. Add 1M hydrochloric acid to a boiling tube and place it in a 60°C water bath.
2. Cut 1 cm from the tip of a growing root (e.g. onion), as this region contains actively dividing cells.
3. Place the root tip in the hydrochloric acid for 5 minutes to soften the tissue and separate the cells.
4. Remove the root tip, rinse with cold water and leave it to dry on a paper towel.
5. Place the root tip on a microscope slide and cut 2 mm from the very tip. Discard the remaining root.
6. Use a mounted needle to break up and spread the root tip cells into a thin layer. Add a few drops of acetic orcein stain and leave for a few minutes to stain the chromosomes.
7. Place a coverslip at an angle over the cells, cover with folded filter paper and press down firmly (squash) to make the tissue thinner.
why use HCL in core practical 2 investigating mitosis
breaks up tissue into individual cells, breaks up protein in cellulose
why do we use ocetic stain
stop mitosis and stain chromosome
why must avoid putting coverslip sideways
avoid damaging cells
why use meristem for mitosis
mitosis occur in meristem more frequently , chromosome visible
why squash sample and break tip open
thin specimen
light can pass through
and identify stages of division
what info does cell count give in mitosis
duration of cell cycle
hazards in mitosis prac
dont apply too much pressure on glass- cause cuts
HCL , stain - irritant = corrosive wash hands and wear goggles
sharp equipment mount needle - cut away from urself + flat surfaces