1/31
Vocabulary practice flashcards covering environmental factors, aerodynamic drag, weather resources, avionics assembly, LiPo handling, and ground control systems from UAS 213 Module 3.
NOAA Aviation Weather Center
An aviation weather service providing active and historical reports including Meteorological Automated Reports (METARs), Terminal Area Forecasts (TAFs), and Pilot Reports (PIREPs).
Weather Underground
A weather resource supplying historical and real-time local data on winds and precipitation via a semi-open approach from privately and publicly owned weather stations.
Windy.com
A comprehensive global wind-modeling platform monitoring current worldwide wind patterns and flows using data aggregated from global weather stations and supplementary extrapolations.
Weather-Spark
A climate resource used to track long-term climate trends, monthly precipitation likelihoods, and historical weather data across a 10-year period.
Form Drag
Aerodynamic resistance resulting from the cross-sectional shape of an airframe and the pressure variation created around the object as it moves through air.
Induced Drag
Drag generated by the airflow moving over and under a lifting wing profile; considered a useful by-product of creating aerodynamic lift.
Skin Friction
Aerodynamic frictional drag caused by the contact of moving air with the surface roughness of an airframe; smooth, waxed surfaces produce less friction than rough ones.

Factors Affecting Drag (NASA Model)
The three aerodynamic categories governing drag: The Object (shape and size), The Motion (velocity and inclination to flow), and The Air (mass, viscosity, and compressibility).
Headwind (sUAS Performance Effect)
Wind flowing directly against the front of an aircraft; increases airspeed over the wings, allowing fixed-wing UAS to reduce throttle output and conserve power at the cost of ground speed.
Tailwind (sUAS Performance Effect)
Wind blowing from the rear of the aircraft; reduces sensed airspeed over the wings, forcing fixed-wing autopilots to increase motor power to maintain target airspeed while increasing ground speed.
Crosswind (sUAS Performance Effect)
Wind directed against the side of an aircraft; pushes the airframe off course, prompting the autopilot to supply continuous yaw correction to remain on the programmed track.
80% MGTOW Rule
A propulsion design guideline stipulating that lifting an aircraft's Maximum Gross Takeoff Weight should require at most 80% of total motor power, leaving a 20% margin for wind resistance and emergency maneuvers.
Grommet
A flexible sealing component (e.g., 3D-printed TPU) installed in airframe cable ports to block moisture and airborne dust while protecting wiring from being abraded by sharp structural edges.
Conformal Coating
A polymeric liquid resin sprayed onto printed circuit boards (PCBs) to waterproof electronics against precipitation and humidity, weighing approximately 317g/L (0.6lbs).
IMU Thermal Sensitivity
The phenomenon where temperature fluctuations alter the viscosity of the silicon vat encasing micromechanical gyroscopes and accelerometers, creating sensor drift and Kalman filter navigation failures.
Nichrome Wire Heating Element
An active heating component encased within a ceramic frame (used in Pixhawk 2 autopilots) to keep IMU sensors at optimal operational temperatures in cold environments.
LiPo Low-Temperature Drop
Performance degradation in Lithium Polymer batteries occurring below 50∘F(10∘C), with severe voltage sag and diminished discharge capacity occurring below 20∘F(−7∘C).
LiPo Maximum Operating Temperature
The upper thermal limit of 140∘F(60∘C) beyond which LiPo batteries destabilize, suffer chemical breakdown, and risk in-flight thermal runaway or fire.

Propeller Leading Edge Deterioration
The physical erosion and dulling of a propeller's leading edge caused by high-velocity airborne dust and sand particles acting like abrasive sandpaper, degrading thrust and aerodynamic balance.
GPS Mast
An elevated mounting stalk that elevates the GPS module and internal magnetometer above motors, power distribution boards, and ESCs to minimize electromagnetic interference (EMI).
EMI Shielding
The application of electromagnetic-reflective materials (such as aluminum foil) positioned underneath a GPS module to deflect electromagnetic interference emitted by lower electronics while leaving the top clear for satellite signals.
PWM Converter
A hardware board that adapts individual 3-pin ESC servo cables into a single 10-pin JST connector for direct interfacing with an autopilot's I/O PWM MAIN port.
Telemetry Air Unit
An onboard transceiver (commonly 915MHz, 100mW) connected to an autopilot telemetry port to stream vehicle data to and receive commands from a ground control station.
MAVLink
Micro Autonomous Vehicle Link; a lightweight serial communication protocol used by autopilots (such as PX4 and ArduPilot) to send telemetry, sensor status, and mission commands between UAS and ground software.
Transmitter Controller Receiver
An onboard receiver unit (e.g., RadioLink R9DS) wired to the autopilot RC/SBUS port to relay real-time manual control inputs from a handheld transmitter.
Safety Pilot
A designated ground operator holding a manual transmitter controller who remains prepared to take manual flight control if autonomous or flight stability algorithms fail.
1C Charge Rate
A battery charging current equivalent to the pack's milliampere-hour rating divided by 1000 (e.g., 5A for a 5000mAh battery), typically achieving a full charge within 45 to 60minutes.
Battery C-Rating
A multiplier indicating the maximum continuous safe discharge current of a battery; calculated as the C-value multiplied by the pack's 1C amperage rating (e.g., 50C×5A=250A).
LiPo Storage Charge
The safe resting state for LiPo packs (≈50% capacity or ≈3.8V per cell; 14.8V total on a 4S pack) required when batteries are not in active use.
LiPo Safe Storage Limit
A safety rule mandating that LiPo batteries must not be stored at a full 100% charge for longer than three consecutive days without discharging to storage voltage.
B6 Balance Charger
A programmable multi-chemistry smart charger capable of charging, discharging, and cell-balancing LiPo batteries up to 6S (22.2V) at charge currents up to 5A or 6A.
QGroundControl (QGC)
An open-source (MIT licensed) ground control station software application providing full MAVLink vehicle setup, waypoint mission planning, telemetry monitoring, and flight control.