Fall Protection Competency - Rio Tinto BC Works

Practice fill-in-the-blank flashcards covering fall protection equipment, systems, pre-use inspections, and harness donning procedures from the Rio Tinto BC Works competency evaluation.

Under Part A, the fall protection equipment standards explicitly referenced are CSA, ASTM, and __________.

ANSI

In Part A, the listed fall protection systems include barricades and control zones, safety monitor, hardware, anchor points, and __________ systems.

vertical and horizontal

Under Part B inspection checks, a worker must conduct a pre-use inspection of personal fall arrest systems according to the __________ instructions.

manufacturer's

During pre-use checks in Part B, the worker must verify the __________ inspection date of the equipment.

yearly

In Part C, the harness demonstration task is required to be completed without __________.

error

According to Part C, improperly worn equipment is an identifiable __________ and must be eliminated.

hazard

In Step 1 of donning the harness, the worker must hold the harness by the __________ and verify straps are not twisted.

D-Ring

In Step 2 of donning the harness, the user slips the harness over the arms and onto the __________.

shoulders

In Step 3 and Step 4 of donning the harness, any excess strap must be passed through the __________.

keepers

In Step 3 of donning the harness, the __________ strap must lie directly below and not across the buttock.

sub-pelvic

In Step 4 of donning the harness, the chest strap should be positioned $\_\_\_\_\_\_\_\_\_\_$ below the top of the shoulder.

$$6\text{''}$$

In Step 5 of donning the harness, the D-Ring must lie down the center of the spine between the __________.

shoulder blades

According to the confidentiality clause, the document is the exclusive property of __________.

Rio Tinto Alcan Inc