1/48
Looks like no tags are added yet.
The relationship between the face of the instrument and the tooth surface is called:
Angulation
The ideal face-to-tooth surface angulation for calculus removal is:
60°-80°
An angulation greater than ____ may cause tissue trauma.
90°
An angulation less than ____ may result in burnished calculus.
45°
The three types of force used during instrumentation are:
Pinch pressure, stabilization, lateral pressure
Pressure exerted by the fingers during a modified pen grasp is called:
Pinch pressure
Locking the ring finger joints and pressing the fingertip against the tooth surface is called:
Stabilization
Pressure exerted inward against the instrument handle by the thumb and index finger is called:
Lateral pressure
Assessment strokes require _____ lateral pressure.
Feather-light
Calculus removal requires _____ lateral pressure.
Firm
The three requirements for effective calculus removal are:
Correct angulation, correct adaptation, firm lateral pressure
A smooth residual deposit left after incomplete calculus removal is called:
Burnished calculus
Burnished calculus results when only the _____ layers of the deposit are removed.
Outer
Burnished calculus is difficult to:
Detect and remove
Large calculus deposits should be removed:
In sections
The primary adaptation error on proximal surfaces is failure to adapt the:
Tip-third
Adaptation around line angles is maintained by:
Rolling the instrument handle
Sickle scalers are primarily designed for removing:
Supragingival calculus
A sickle scaler may be used slightly subgingivally when calculus is:
Continuous into the sulcus
Deep subgingival use of a sickle scaler is contraindicated because it may:
Traumatize tissue and gouge root surfaces
Heavy sickle scaler blades reduce:
Tactile sensitivity
A small sickle scaler is most useful under:
Tight contacts
The face of a sickle scaler forms a _____ angle with the terminal shank.
90°
A sickle scaler has _____ cutting edges.
Two
The leading third of the cutting edge is the:
Tip-third
The 204S sickle scaler is designed for:
Tight narrow contacts and interproximal areas
The Nevi 3 sickle scaler is designed for:
Light to moderate calculus
For a correct posterior working end, the terminal shank should be:
Parallel to the tooth surface
The memory aid used for selecting the correct posterior working end is:
Posterior equals Parallel
The cutting edge closest to the handle is the:
Inner cutting edge
The cutting edge farthest from the handle is the:
Outer cutting edge
The inner cutting edge is used on _____ surfaces.
Distal
The outer cutting edge is used on _____ surfaces.
Facial, lingual, and mesial
The memory aid used for cutting edge selection is:
Start in and move out
Recommended angulation for a sickle scaler is:
70°-80°
Keeping the lower shank parallel to the tooth surface creates an angulation of:
90°
Correct sickle scaler angulation is achieved by:
Tilting the lower shank toward the tooth surface
Instrumentation begins at the:
Distobuccal line angle
The instrumentation sequence begins on the _____ surface.
Distal
The sequence reminder before instrumentation is:
Me, My patient, My light, My mirror, My grasp, My finger rest, My adaptation
The cutting edge that contacts the tooth on the distal surface is the:
Inner cutting edge
The cutting edge that contacts the tooth on the mesial surface is the:
Outer cutting edge
One effect of excessive angulation is:
Tissue trauma
One effect of insufficient angulation is:
Burnished calculus
The primary purpose of firm lateral pressure is to:
Fracture and remove calculus
Finger muscles should relax between strokes to reduce:
Muscle fatigue
The fulcrum finger serves as the:
Support beam during instrumentation
The face-to-tooth surface angulation for calculus removal ranges from:
45°-90°
The instrument area that must remain adapted at all times is the:
Tip-third of the cutting edge