1/22
Looks like no tags are added yet.
how do you measure voltage drop?
need to sample the energy before and after the circuit using a voltmeter
which component is a voltmeter placed parallel to?
the component whose potential difference you want to measure
how do you measure current?
placing an ammeter in the series of the circuit
how do you know if a resistor is ohmic?
Both sides should be equal after plugging the resistance unit into the Ohm's law equation
how do you if a resistor is non-ohmic?
Both sides are equal after plugging the resistance unit into the Ohm's law equation
what kind of graph shows a non-ohmic resistor?
a non-linear graph
what kind of graph shows an ohmic resistor?
a linear graph
what is a series circuit?
the electrical components are connected one after the other
what is the total resistance of a series circuit?
The sum of the resistance of each component
characteristic of the current of a series circuit
the current is the same flowing throughout
characteristic of the voltage of a series circuit
has differing voltage depending on the resistance of each electrical component
What is a parallel circuit?
a circuit that has electrical components connected on different pathways from each other
what is the total resistance of a parallel circuit?
1/R= 1/R1 + 1/R + 1/R3 + 1/R4 ....
characteristic of the current of a parallel circuit?
has differing current flowing through depending on the resistance of the separate pathways
characteristic of the voltage of a parallel circuit?
has the same voltage drop across the circuit
what type of ciruit is simpler and cheaper to wire?
series because they require less wiring
what circuit has lower overall resistance?
series
which circuit has equal current throughout all components?
series
which circuit has a single point of failure?
series because if one component fails, the entire circuit breaks and no current flows
what circuit has lower individual component voltage?
series because the voltage is divided between each component
what happens when voltage is divided amongst components?
components have less voltage individually resulting in lower brightness
why are individual loads in series circuits difficult to control?
each component cannot be controlled seperately
what can cause a resistor to become non-ohmic?
a change in temperature