1/77
Looks like no tags are added yet.
What two tissues form the dentin-pulp complex, and why are they treated as one unit?
Dentin and pulp; they share a developmental origin (the dental papilla), sit in close proximity, and depend on each other.
What is the composition of mature dentin by weight?
70% inorganic (mineral), 20% organic, and 10% water.
What is the main mineral in dentin, and what is its chemical formula?
Calcium hydroxyapatite, Ca10(PO4)6(OH)2.
How does the hardness of dentin compare with enamel and bone?
Dentin is less hard than enamel but slightly harder than bone.
Why does dentin give the enamel crown a yellow hue?
Enamel is translucent, so the underlying yellow dentin shows through.
How does dentin appear on a radiograph compared with enamel and pulp?
More radiolucent (darker) than enamel but more radiopaque (lighter) than pulp.
Why does exposed dentin wear (attrition) faster than enamel?
Its mineralized content is lower.
Why does exposed dentin pick up intrinsic stains?
It is porous and permeable because of its high organic content and dentinal tubules, so it acts like a sponge.
At what pH does dentin demineralize?
Less than 6.8.
What is dentinogenesis?
The formation of the initial dentin matrix (predentin) during the apposition stage of tooth development.
What is predentin made of?
Nonmineralized collagen fibers produced by odontoblasts, mostly Type I with small amounts of Types III and V, plus dentin phosphoprotein.
What is the role of dentin phosphoprotein?
It regulates mineralization of dentin because it is highly attracted to calcium.
How much predentin do odontoblasts produce per day?
About 4 micrometers.
Why does dentin keep forming after tooth eruption while enamel does not?
Ameloblasts are lost after eruption, but odontoblasts remain along the outer pulpal wall.
How does an odontoblast differ from bone or cementum cells?
Its cell body is not entrapped in its product; only one long cytoplasmic extension (the odontoblastic process) remains in the dentin.
What happens during primary mineralization of dentin?
Calcium hydroxyapatite crystals form as globules (calcospherules) in the predentin collagen, expanding and fusing together.
What happens during secondary mineralization of dentin?
New globules form in partially mineralized predentin and layer onto the initial crystals, but they tend to fuse incompletely.
What is globular dentin?
Lighter rounded areas where primary and secondary mineralization occurred with complete crystalline fusion.
What is interglobular dentin?
Darker arclike areas where only primary mineralization occurred and globules did not fuse completely, making it slightly less mineralized.
Where is interglobular dentin especially evident?
In coronal dentin near the DEJ and in anomalies such as dentin dysplasia.
What are dentinal tubules?
Long tubes in dentin extending from the DEJ (crown) or DCJ (root) to the outer pulpal wall, narrower near the DEJ/DCJ and wider near the pulp.
What does a dentinal tubule contain?
Dentinal fluid, an odontoblastic process, and sometimes part of an afferent axon.
How does dentin receive its nutrition if it is avascular?
Through tissue fluid in the dentinal tubules that originates from blood vessels in the adjacent pulp.
What is the primary curvature of dentinal tubules?
The overall large S-shaped course of the tubules.
What is the secondary curvature of dentinal tubules?
Small delicate curves within the primary curvature reflecting smaller daily changes in odontoblast direction.
Why is the primary curvature of the tubules clinically important?
The pulp may be affected at a more apical level than where the external injury (such as caries) occurred, which must be considered during cavity preparation.
Which nerve fibers in dentin produce sharp pain and which produce dull aching pain?
A fibers (delta and beta), stimulated mostly by cold, produce sharp pain; C fibers produce dull aching pain and are responsible for referred pain.
What is peritubular (intratubular) dentin?
Dentin that forms the wall of the dentinal tubule; it is highly mineralized.
What is intertubular dentin?
Dentin found between the tubules; highly mineralized but less so than peritubular dentin.
What is mantle dentin?
The first dentin formed, located near the DEJ under enamel, with collagen fibers perpendicular to the DEJ, von Korff fibers, and higher mineralization.
What is circumpulpal dentin?
The dentin around the outer pulpal wall that forms after mantle dentin, makes up the bulk of the dentin, and has collagen fibers mostly parallel to the DEJ.
What is primary dentin?
Dentin formed before completion of the root's apical foramen or foramina; it makes up most of the dentin and has a regular tubule pattern.
What is secondary dentin?
Dentin formed after completion of the apical foramen, continuing throughout the life of the tooth, forming more slowly and with a slightly irregular tubule pattern.
Where does most secondary dentin form, and what is the result?
On the roof and floor of the pulp chamber, causing pulp recession.
What causes the dark line between primary and secondary dentin?
An abrupt change in the course of the odontoblasts during appositional growth as the apex is completed.
What is tertiary dentin?
Dentin formed quickly in local regions in response to injury of exposed dentin (caries, cavity preparation, attrition, or recession), with an irregular tubule course.
What is the difference between reactive and reparative tertiary dentin?
Reactive dentin is formed by existing odontoblasts; reparative dentin is formed by new odontoblasts that differentiate from pulp mesenchymal cells after the original ones die.
What is sclerotic dentin?
A type of tertiary dentin seen with chronic injury and aging in which odontoblastic processes die and the empty tubules become occluded with mineral, making the dentin dense, radiopaque, and transparent.
Why is sclerotic dentin clinically beneficial?
It reduces dentin permeability and may prolong pulp vitality.
What is the smear layer?
A roughly 1 micrometer thick layer of adherent debris produced when dentin is cut; it lowers permeability but interferes with bonding restorative materials.
What is dentinal hypersensitivity?
Short, sharp pain caused by exposed, open dentinal tubules.
What does the hydrodynamic theory propose?
Stimuli cause evaporation, movement, or ionic changes in dentinal fluid, which stimulate A-delta fibers near the dentin-pulp interface and send pain signals to the brain.
Why does topical anesthetic not stop dentinal hypersensitivity?
Placing it on the exposed dentin surface does not block the sensation the way it would on fully innervated tissue.
What kinds of stimuli can trigger dentinal hypersensitivity?
Thermal changes, mechanical irritation, dehydration, and chemical exposure (such as hypertonic sweet, salty, or sour foods or whitening agents).
How can dentinal hypersensitivity be treated?
Desensitizing agents that remineralize (fluoride, CPP-ACP), block the tubule openings, or interfere with nerve transmission; restorations in severe cases.
Why can dentin be exposed at the CEJ in some teeth?
In about a third of teeth the enamel and cementum do not meet, leaving a gap with dentin exposed.
How does dentinal caries spread, and why is it faster than enamel caries?
Bacteria use the dentinal tubules as chutes toward the pulp, and dentin has a higher organic composition than enamel.
What are the imbrication lines of von Ebner?
Incremental lines in dentin, like tree growth rings, that run at 90 degrees to the tubules and appear about every 20 micrometers (every fifth daily increment).
What are the contour lines of Owen?
Groups of adjoining parallel imbrication lines showing a disturbance in body metabolism that affects odontoblasts.
What is the neonatal line?
The most pronounced contour line of Owen, caused by the trauma of birth.
What is Tomes granular layer?
A spotty-looking zone of dentin beneath the root cementum near the DCJ; its cause and clinical significance are unknown.
How does dentin change with aging?
Tubules narrow from peritubular dentin deposition (some obliterate), odontoblasts lose organelle content, and dentin becomes more exposed through attrition and recession.
Which dentin feature is considered one of the best parameters for dental age estimation?
Dentinal translucency.
Where does pulp come from developmentally?
From the central cells of the dental papilla of the tooth germ.
What are the four functions of the pulp?
Formative (supports and maintains dentin), sensory, nutritional, and protective.
How are all sensations in the pulp perceived?
As pain only, including extreme temperature changes and vibration.
What are the two main divisions of pulp in the pulp chamber?
Coronal pulp (in the crown) and radicular pulp (in the root canal).
What are pulp horns, and where are they found?
Extensions of coronal pulp into the cusps of posterior teeth; not found in anterior teeth, and they recede with age.
What is the apical foramen?
The opening from the pulp into the surrounding PDL near each root apex, allowing arteries, veins, lymphatics, and nerves to enter and exit.
What are accessory (lateral) canals, and how do they form?
Extra openings from the pulp to the PDL that form when Hertwig epithelial root sheath encounters a blood vessel and root structure forms around it.
What are the four microscopic zones of pulp from outer to inner?
Odontoblastic layer, cell-free zone, cell-rich zone, and pulpal core.
What does the odontoblastic layer contain?
Odontoblast cell bodies and the cell bodies of afferent axons from the dentinal tubules.
What is notable about the cell-free zone?
It has fewer cells than the odontoblastic layer but is not truly cell free; it contains a nerve and capillary plexus.
What are the two largest cell groups in the pulp?
Fibroblasts are the largest group, followed by odontoblasts.
What are dental pulp stem cells (DPSCs)?
Undifferentiated mesenchymal stem cells in the pulp that can become fibroblasts or odontoblasts after injury.
What types of fibers does pulp contain?
Mostly collagen fibers and some reticular fibers; there are no elastic fibers.
What types of nerves are in the pulp?
Myelinated (20% to 30%) and unmyelinated (70% to 80%), mostly nociceptors that relay pain.
How does pulp change with aging?
Pulp horns recede, cells (especially undifferentiated mesenchymal cells) and water decrease, collagen increases, and the pulp becomes more fibrotic with reduced regenerative capacity and a smaller cavity (pulp recession).
How can obliteration of the apical foramen lead to tooth death?
Cementum deposits block vessels (especially veins), causing vascular congestion and pulpal necrosis, resulting in slow, painless tooth death.
What are pulp stones (denticles)?
Mineralized masses in the pulp; true stones have dentin structure with tubules and odontoblastic processes, while false stones are amorphous.
Why can pulpitis cause extreme pain?
The inflammation is confined within the dentin, so the pressure from inflammatory edema presses on the afferent nerves in the pulp.
How is reversible pulpitis treated?
With a pulp cap or pulpotomy using a bioceramic material (which has replaced calcium hydroxide), followed by a permanent restoration.
How is a dead pulp from irreversible pulpitis treated?
With a pulpectomy, then filling the pulp chamber and canals with gutta-percha during endodontic (root canal) therapy.
Why may an endodontically treated tooth darken and become brittle?
It is no longer vital; darkening is from leftover degradative products of pulpal necrosis passing along the dentinal tubules, and the tooth can break during mastication.
What procedure may be needed if pulpitis causes an abscess or cyst in the periodontium?
An apicoectomy to remove the apical lesion.
How can iatrogenic pulp injury be prevented?
Water-cooled rapidly rotating handpieces to reduce heat and vibration, selective polishing, and liners and cement bases under restorative materials.
How does nicotine affect the pulp?
It reduces vascularity, weakening the pulp's ability to fight disease and increasing the risk of endodontic therapy by over 70%.
Why are DPSCs of interest, and where are they most viable?
They are multipotent (neural crest origin), easy to collect, and useful for regenerative medicine and banking; they are most viable in primary teeth.