1/44
Looks like no tags are added yet.
What equation is used to determine if a ceramic is mostly covalent bonding or ionic bonding?
%IC = {1-exp^(-0.25(Xa-Xb)^2)}*100
A Frenkel defect involves ...
a cation vacancy and cation interstial pair
A semicrystalline polymer will exhibit __________________.
a glass transition temperature and a melting temperature
If the radius ratio (rc/ra) is 0.5, the the ceramic crystal structure will be ...
NaCl
A thermoplastic polymer is
able to be reversibly cooled and reheated
A possible structure for an ionic ceramic can be determined from .......
charge neutrality and cation to anion radius ratio
What type of bond is found between atoms within hydrocarbon molecules?
covalent bonds
The equation for the degree of polymerization is ...
DP = Mn / m
What mechanical property is greater for polymers than for metals?
ductility or % EL
Which type of polymer would you expect to have the highest % elongation to failure?
elastomer
What test is used to determine mechanical properties of ceramics?
flexture bend test
Compared to ceramic materials, ceramic-matrix composites have better/higher:
fracture toughness
Vulcanization of rubber ...
increases the elastic modulus of an elastomer
In nucleation, the critical radius, r*:
indicates that particles greater than r* will grow
In polymers, crazing ...
leads to the formation of small microvoids
Which of the following Fe-Fe3C alloys and associated microstructures has the highest tensile strength?
Martensite
The equation for weight average molecular weight is....
Mw = Σ wi * Mi
A phase transformation reaction, such as the eutectoid γ → α + Fe3C, generally proceeds in two steps when just below the transformation temperature. These steps are:
nucleation and growth
Tempered glass resists brittle fracture because..
of high compressive stresses at and near the surface
What factors can lead to failure in ceramics?
surface defects, presence of pores or internal cracks and an application of loading, bending or torsion
The deformation behavior of a thermoplastic becomes increasingly brittle as ....
temperature drops, strain rate increases and/or molecular weight increases
Silicate ceramics are composed of ...
the most common elements on earth, Si and O
A ceramic denoted as an AX structures means that AX specifies
the stoichiometery
A thermoset polymer is
typically has a network or crosslinked structure
Chain stiffness in a polymer increases:
when double bonds, aromatic rings or bulky side groups are added to the polymer chain
If a ceramic is mostly covalently bonded, what crystal structure would it form?
ZnS
An image of an syndiotactic polymer is ...

An image of a network polymer is ...
"A diagram of a network

An image of an isotactic polymer is ...
Picture

An image of a graft polymer is ...
Picture

An image of a branched polymer is ...
Picture

An image of a semi-crystalline polymer is ...
Picture

An image of a cross-linked polymer is ...
Picture

An image of a block polymer is ...
Picture2

The conductivity of a metal:
decreases with an increase in temperature
Imperfections in metals such as grain boundaries and dislocations will .....
increase resistivity of the metal
Semiconductors have a band gap ....
between the values of a conductor (metal) and insulator (ceramic or polymer)
Resistivity is a material property that ...
is geometry independent
Resistance is a property of a conductor or component that opposes the flow of electric current and is .....
geometry dependent
An intrinsic semiconductor contains
no dopants
An extrinsic semiconductor contains
dopants that create electrons or holes
As the temperature of an intrinsic semiconductor increases,
its conductivity increases because more electron-hole pairs are generated.
The Hall Effect measures
charge carrier concentration and mobility
An LED (light emitting diode) is a p-n junction device that
emits visible light
A MOSFET transistor is a device that
amplifies a signal or is used as a switching device in computer processing