2009 Construction Supervisor Test questions - International Residencial Code (IRC)

0.0(0)
Studied by 0 people
call kaiCall Kai
learnLearn
examPractice Test
spaced repetitionSpaced Repetition
heart puzzleMatch
flashcardsFlashcards
GameKnowt Play
Card Sorting

1/13

encourage image

There's no tags or description

Looks like no tags are added yet.

14 Terms

1
New cards

R401.3 Lot Drainage

Lots shall be graded to drain surface water away from foundation walls.

  • The grade shall fall a minimum of 6 inches within the first 10 feet


2
New cards

Table R402.2 Minimum Specified Compressive Strength of Concrete

What is the minimum specified compressive strength of basement slabs and interior slabs on grade, except garage floor slab if the weathering potential is negligible

3
New cards

R404.1.8 Rubble Stone Masonry

Rubble stone masonry foundation walls shall have a minimum thickness of 16 inches

4
New cards

R404.2.4 Backfilling

Wood foundation walls shall not be backfilled until the basement floor and first floor have been constructed or the walls have been braced

5
New cards

R404.3 Wood Sill Plates

Wood sill plates shall be minimum of 2-inch by 4-inch nominal lumber.

6
New cards

R405.2.2 Vapor Retarder

A 6-mil-thick polyethylene vapor retarder shall be applied over the porous layer with the basement floor constructed over the polyethylene.

7
New cards

R406.1 Concrete and Masonry Foundation Damp proofing

Masonry walls shall have not less than 3/8 inch Portland cement parking applied to the exterior of the wall.

8
New cards

Table R405.1

  • What are the drainage characteristics of Well-graded levels?

  • What are the draining characteristics of Silty sand?

  • What are the draining characteristics of Clayed gravels?

  • What are the drainage characteristics of inorganic clays of high plasticity, flat clays?


9
New cards

1507.2.6 Fasteners Roof Covering

Where the roof sheathing is less than ¾ inch thick, the nails shall penetrate through the sheathing.

  • Fastening for asphalt shingles shall be galvanized, stainless steel, aluminum or cooper roofing nails…


10
New cards

1507.2.7 Attachment

Shingles shall have the minimum number of fasteners required by the manufacturer, but not less than four fasteners per strip shingle or two fasteners per individual shingle

  • Where the roof slope exceeds 21 units vertical in 12 units horizontal (21:12)

  • Shingles shall be installed as required by manufacturer


11
New cards

1507.2.8 Underlayment Application

A minimum 19-inch-wide strip of underlayment felt parallel with and starting at the eaves

  • Fastened sufficiently to hold in place


12
New cards

1507.2.8.1 High Wind Attachment

Fasteners are to be applied along the overlap at a maximum spacing of 36 inches on center

13
New cards

1507.2.8.2 Ice Barrier

Exception: Detached accessory structures that contain no conditioned floor area

14
New cards

1507.2.9.1 Base and Cap Flashing

Base flashing shall be of either corrosion-resistant metal of minimum nominal 0.019 inch thickness or mineral-surfaced roll roofing weighing a minimum of 77 pound per square feet.