MECH2100 Final Exam Study - Gear Design, Shaft Design

0.0(0)
Studied by 0 people
call kaiCall Kai
learnLearn
examPractice Test
spaced repetitionSpaced Repetition
heart puzzleMatch
flashcardsFlashcards
GameKnowt Play
Card Sorting

1/20

encourage image

There's no tags or description

Looks like no tags are added yet.

21 Terms

1
New cards

Define the pitch circle

The meshing gear pair behaves as if two smooth rollers were rolling on each other.

2
New cards

Define the point point

The point of tangency of the pitch circle.

3
New cards

Define the pitch diameter

The diameter of the pitch circle, denoted by D

4
New cards

Define the pitch

The arc length between the same points on two adjacent teeth.

5
New cards

Define the addendum

The radial distance from the pitch circle to the tip of the teeth.

6
New cards

Define the dedendum

The radial distance from the pitch circle to the bottom of the teeth.

7
New cards

Define the pinon.

When two gears are in mesh, the smaller one is called the pinon.

8
New cards

Tooth profile: What is the module?

How much of the pitch diameter is shared by a tooth.

9
New cards

Tooth profile: What is the diametral pitch, Pd?

How many teeth are distributed to one inch of pitch diameter.

10
New cards

What is an involute tooth profile?

The meshing of two gears need to be constant and smooth which is achieved by a special tooth profile called the involute profile.

11
New cards

Involute tooth profile: What happens to angular velocity?

The angular velocity ratio is constant and is insensitive to centre distance error.

12
New cards

Involute tooth profile: What is the line of action and pressure angle?


The contact force always acts along the line of action which is normal to tooth faces. The line of action is at the pressure angle, typically 20 degrees to the pitch circle tangent and passes through the pitch point.

13
New cards

Involute tooth profile: Where does contact start and end?

Contact starts near the addendum circle and ends near driver addendum circle. Teeth do not always mesh at pitch point and contact is not always constant.

14
New cards

Involute tooth profile: What are key requirements?

Both gears need the same module and pressure angle to mesh

15
New cards

Define the contact ratio

The number of teeth on average in contact at any time. In general, the greater the contact ratio the smoother the operation is. Generally, need greater than 1.2

16
New cards

How do we overcome tooth interference?

Control teeth numbers, addendum/dedendum modification, tooth thickness modification.

17
New cards

Why do some gears fail?

Tooth overloading, initial stresses, poor tooth design, incorrect material, incorrect heat treatment

18
New cards

What are the two gear teeth failure modes?

Breakage of the tooth due to bending fatigue due to bending stress and failure of the tooth surfaces due to surface fatigues due to contact stress. For surface failure, we mainly design against pitting and spalling

19
New cards

What is a key feature of the stress equations and factors?

J differs for pinion and gear, so bending stress differs. Ko,Km,Kv,Ks are shared so contact stress is the same.

20
New cards

What is required from gear design?

Calculated bending and contact stresses. The strengths must be higher than the stresses, then the tooth is safe. In other words, Sat > bending stress.

21
New cards