1/29
Looks like no tags are added yet.
primary purposes of driving raises?
exploration, manway, orepass
Drilling in Rock Breakage is also called?
rock penetration
Which underground material-handling equipment consists of a continuous loop of reinforced rubber belting supported by rollers and driven around pulleys to transport muck or ore along a fixed route?
conveyor belt
In a timber set supporting an underground drift, which horizontal member spans the opening above the posts, receives the roof load, and transfers that load to the upright supports?
cap
vertical excavations
raise, winze, shaft
In a four-piece timber set, which horizontal member lies on the mine floor beneath the posts, providing a base and distributing their load over the ground?
sill
A horizontal opening driven into the rock along the bedding plane or vein structure
drift
What do you call the end of any opening driven into the rock?
face
The structure at the surface of a mine shaft that contains the sheave wheels which allow haulage up and down the shaft.
headframe
T or F. An orepass is a shaft
T
The term applied to the timbering or concrete around the mouth of a shaft.
collar
A tunnel driven horizontally into a mountainside providing access to a mineral deposit.
adit
A company has confirmed an orebody located 450 m below surface. The orebody is laterally extensive, but its geometry and grade continuity are not yet sufficiently defined for production planning. Which activity would most appropriately be classified as development rather than production?
Driving a crosscut to intersect the orebody
The term is 'sinking' is a common term for which excavation?
winze
Which is not one of the Technical parameters in the selection of mining methods?
productivity
The process of excavating a vertical or steeply inclined opening from the surface downward to access an underground mineral deposit.
shaft sinking
A system for the transportation of material, such as ore or rock, in buckets suspended from pulleys or grooved wheels that run on a cable, usually stationary.
aerial tramway
considered a spatial parameter in the selection of mining method
strike and dip, deposit shape, contacts and boundaries
An orebody is approximately 80 m north of a main haulage drift. The drift is developed through relatively competent country rock. Which development opening would most directly provide access to the orebody?
crosscut
not a general disadvantage of underground mining?
extensive deforestation
In materials handling, the vertical transport of ore is referred to as?
hoisting
A Slope mine is the most ideal for ore deposits covered by deep overburden by opening the deposit directly from the surface.
false
NOT a primary underground mine opening as used in the industry today?
level
Which tapered wooden piece is driven into a gap between the timber support and the surrounding ground to tighten the set and establish firm contact between the timber and the walls?
wedge
In a typical underground mining cycle, which activity is initiated last in a shift?
blasting
During the face preparation, after the face is surveyed, what step is done after?
face mark up
Scaling involves what process?
Removal of loose rocks in the roof or walls
Which of the following pillars directly support the walls of an excavation and protect raises and winzes during stoping?
rib
This is the entrance of an underground mine connecting from the surface to the horizontal passage.
portal