1/60
For Hocking College NRM-1128, Intro Unmanned Aerial Systems
The layer of gases surrounding Earth. Most weather occurs in the lower layer, the troposphere.
The force exerted by the weight of air above a location. Pressure generally decreases as altitude increases.
A reference pressure of 29.92 inches of mercury (in Hg), or 1013.2 hectopascals, at sea level.
A reference condition at sea level with a temperature of 15°C (59°F) and pressure of 29.92 in Hg.
The average rate at which air temperature decreases with increasing altitude. The presentation uses about 2°C per 1,000 feet as a general average.
A pressure value adjusted to sea level and used to set an aircraft altimeter so it indicates altitude relative to mean sea level.
The altitude indicated when an altimeter is set to standard pressure, 29.92 in Hg. It is used in aircraft performance calculations.
Pressure altitude corrected for nonstandard temperature. It describes how the air density affects aircraft performance.
Conditions in which the air is less dense than standard. Aircraft performance is reduced, often because of high temperature or low pressure.
The amount of air mass in a given volume. Dense air generally supports better aircraft performance than thin air.
Pressure, temperature, and humidity affect aircraft performance. Higher pressure and lower temperature and humidity generally improve performance.
Weather and air density can affect takeoff and landing distance, climb rate, ceiling, payload, range, speed, and maneuverability.
The rate at which pressure changes over a distance. A steeper gradient, shown by closely spaced isobars, is associated with stronger winds.
Lines on a weather map connecting locations with equal atmospheric pressure.
Rising and sinking air movements caused by uneven heating of the surface. Dark, bare surfaces heat quickly, while water and vegetation heat more slowly.
Wind shear
A change in wind speed and/or direction over a short distance. Low-level wind shear is especially hazardous near takeoff and landing.
A strong, localized downdraft that spreads outward near the ground and can cause sudden, dangerous wind changes.
The temperature to which air must cool for it to become saturated. When the temperature and dew point are close, visible moisture is more likely.
The state in which air contains as much water vapor as it can hold at its current temperature.
Ice crystals that form when the dew point is below freezing and the surface where moisture collects is at or below freezing.
A cloud at or near the ground that reduces visibility.
Radiation fog
Fog that forms when the ground cools rapidly and chills moist air near the surface, often in low-lying areas with little wind.
Fog that forms when warm, moist air moves over a colder surface, often with wind.
Fog that forms when moist air is pushed up a slope, cools, and reaches saturation.
Fog that forms when cold, dry air moves over warmer water. It can be associated with low level turbulence and icing.
High, thin clouds made mostly of ice crystals. They can occur in fair weather or signal an approaching weather system.
Low, layered clouds that can produce low ceilings and reduce visibility.
Puffy clouds associated with rising air. Strong vertical development can signal unstable conditions.
A thick, layered cloud commonly associated with steady precipitation.
A lens shaped cloud that can appear stationary near mountains and signal strong winds or turbulence.
Air that resists vertical movement. Stable conditions generally limit the development of towering clouds.
Air that readily rises when lifted, which can support clouds with strong vertical development and thunderstorms.
Sufficient water vapor, an unstable lapse rate, and an initial lifting action are needed for a thunderstorm to form.
The boundary between two air masses with different characteristics. A front can bring changes in temperature and wind direction.
The leading edge of advancing cold air. It can lift warmer air and is often associated with a narrow band of thunderstorms.
The leading edge of advancing warm air, which typically rises over cooler air ahead of it.
A boundary between air masses that is moving very little.
A front formed when a faster moving cold front catches up to a warm front and lifts the warm air.
A narrow band of thunderstorms, often associated with a cold front.
Ice that builds on an aircraft when it flies through visible moisture at a temperature of 0°C or colder.
The greatest horizontal distance at which prominent objects can be seen with the naked eye. Aviation reports commonly give it in statute miles.
A standardized report of observed weather conditions at an airport, usually issued hourly and updated when significant changes occur.
Terminal Aerodrome Forecast: a forecast of expected weather for an airport area over a set period.
Automated Weather Observing System: equipment that measures and reports local weather conditions, often by radio at an airport.
Automated Surface Observing System: equipment that collects and reports surface weather observations at airports and other sites.
Aviation time reference based on Coordinated Universal Time (UTC). A Z after a time indicates it is given in this time standard.
The group showing the day of the month and observation time in Zulu time, such as 161853Z for the 16th day at 18:53Z.
A code for wind direction and speed, with gusts included when present. For example, 20016G22KT means wind from 200° at 16 knots, gusting to 22 knots.
Knots, a unit of speed equal to one nautical mile per hour. It is used for wind speed in aviation weather reports.
Statute miles, a unit commonly used for visibility in U.S. aviation weather reports.
METAR codes describe how much of the sky is covered: FEW means few clouds, SCT scattered, BKN broken, and OVC overcast.
A METAR group giving temperature and dew point in Celsius. An M before a number means the value is below zero.
A METAR group beginning with A that gives the altimeter setting in inches of mercury, such as A3003 for 30.03 in Hg.
-RA / RA / +RA
METAR codes for light rain and heavy rain. A minus sign indicates light intensity, and a plus sign indicates heavy intensity.
METAR codes for mist (BR) and fog (FG).
METAR code for rain showers. A plus or minus sign can indicate intensity.
METAR/TAF code meaning thunderstorms are in the vicinity of the reporting airport.
In a TAF, FM introduces a forecast change beginning (from) at a specified time.
In a TAF, TEMPO marks temporary fluctuations in conditions expected during the stated period.
PROB40
In a TAF, PROB40 indicates a 40 percent probability of the specified weather during the stated period.
Ceiling
The height above ground level of the lowest broken or overcast cloud layer, or vertical visibility into an obscuration.