1/58
Looks like no tags are added yet.
In the distillation experiment, the purpose of a fractionating column was to
Give a better separation for the mixture to be distilled
Which liquid would be most easily separated from water by fractional distillation?
1. BP=97 deg C
2. BP=82 deg C
3. BP= 65 deg C
4. BP=118 deg C
5. BP=80 deg C
3's BP is the farthest from 100 deg C
Which alkyl halide would react the fastest in a nucleophilic substitution using silver nitrate? in EtOH (weak nucleophile, protic solvent)?
3-bromo-3-methylpentane, because it is the most highly substituted and SN1 rxn
In the recrystallization experiment, you determined the identity of your unknown from:
its melting point
Refluxing
heats without loss of solvent
Which alkyl halid would react fastest in a Nucleophilic substitution using NaI in Acetone? (strong nucleophile, aprotic solvent)?
1-bromopentane (least substituted, SN2)
In the transfer hydrogenation of olive oil experiment, the source of hydrogen was
cyclohexene
Why was cyclohexene used in the transfer hydrogenation of olive oil experiment, instead of actual H2?
H2 is explosive
Which would be the most effective way to separate two miscible liquids whose BP's are 25 degrees C apart?
Fractional distillation
Be able to draw and name the important parts of a distillation apparatus
round bottom flask
distillation head
condenser
side arm
thermometer
short stem funnel
graduated cylinder
List the 4 general factors that affect the separation obtained on gas chromatography
column temperature
column length
rate of carrier gas flow
type of stationary phase
Why is a boiling chip added to the distilling flask before performing distillation?
to prevent bumping
How can you try to induce precipitation of a dissolved compound from solution?
Add seed cyrstal
Add solvent to which the solute is insoluble
Scratch inner wall of flask with stirring rod
What were the 3 components present in the extraction of the 3-compound mixture experiment?
Benzocaine-base
Benzoic acid- acid
Fluorenone- neutral
A mixture of 2 compounds will have a melting point that is
lower than either of the pure components
If given a mixture of two different compounds, the melting point of the mixture will be:
lower than both of the melting points
Which would be the most efficient way of separating two miscible liquids whose boiling points are greater than 100 deg C apart?
simple distillation
Which liquid would be most efficiently separated from water by simple distillation?
1. BP=75
2. BP=110
3. BP=85
4. BP=200
4. BP is greater than 100 deg different than BP of water
In gas chromatography, the stationary phase is:
a nonvolatile liquid
In the distillation experiment, the purpose of a fractionating column is to
increase the number of theoretical plates of distillation
Which solvent would not be appropriate for extracting caffeine from a solution of diet coke?
ethanol because it's too polar
In the extraction of a 3 component mixture, benzoic acid is isolated from the aqueous layer using:
HCl (aq)
Impurities do what to the melting point?
Depress and broaden its range
In the hydrogenation of olive oil experiment, what was the catalyst used to transfer the hydrogen?
Palladium on Carbon
A mixture of 95% EtOH and 5% H2O is a azeotrope. This mixture can be separated how?
only by chemical means
An azeotrope is:
a mixture of liquids that cannot be separated by fractional distillation; retains the same composition in vapor state as liquid state
In the three component mixture experiment, benzocaine (neutral) was extracted from the aqueous layer by extraction with
NaOH (aq)
Draw the structures of 3 components isolated in the 3 component mixture experiment
...
In preparation of diphenylacetylene, what is the name of the chemical reagent used as the source of Br2?
Pyridinium hydrobromide perbromide (PHPB)
At the end of recrystallization, what specific technique is used to isolate/collect your purified compound?
suction filtration
What type of specialized melting point technique is used to help determine your unknown compound identity?
50:50 melting point technique
How is the efficiency of the fractionating column measured?
number of theoretical plates
What do you add to the solution to prevent bumping when boiling?
boiling chips
What are the two most general categories of extraction?
liquid-liquid and solid-liquid
What is extracted from nutmeg?
Trimyristin
In separation of a 3 component mixture, in which solvent are all of the components in the experiment soluble?
methylene chloride
How is the neutral component ofyour 3 component mixture separated from your final methylene chloride solution?
Heat so methylene chloride evaporates out
Put remaining liquids through suction filtration to isolate neutral fluorenone crystals
In the Thin Layer Chromatography analysis of analgesics, silica gel was utilized as the:
stationary phase
The 4 active ingredients tested for in the TLC of analgesics lab are:
ibuprofen
caffeine
aspirin/acetylsalicylic acid
acetaminophen
How do you visualize the spots on your TLC plates in the TLC of analgesics lab?
UV light
What solvent system is used to develop your TLC plates in the TLC of analgesics lab?
ethyl acetate with 0.5% solution of acetic acid
What solvent system is used to dissolve the common analgesics in preparation for TLC spotting?
1:1 methylene chloride ethanol solution
In the transfer hydrogenation of olive oil lab, what specific compound is used to filter the catalyst from the reaction mixture after the reflux period is finished?
celite
In the transfer hydrogenation of olive oil lab, what specific compound is used to wash the reaction residue through the filter pipet?
hexane
In the molecular modeling lab, what two tasks did you perform with Spartan?
1. determine the acid and base strengths of molecules
2. determine the lowest energy conformation of a molecule
What the purpose of the energy minimization function in Spartan?
Find the lowest energy conformation of a molecule given
What solvent is used to remove the yellow from the crystals formed in step 1 of the preparation of diphenylacetylene lab?
methanol
What is the intermediate formed in the preparation of diphenylacetylene lab?
Stilbene dibromide
What solvent is used for the reflux step in the preparation of diphenylacetylene lab?
ethylene glycol
What the structure of the final product in the preparation of diphenylacetylene lab?
...
What are the two nucleophiles in the gas chromatography lab?
NH4Cl ammonium chloride
NH4Br ammonium bromide
What are the two general phases that a compound mixture is distributed between during gas chromatography?
1. stationary liquid phase
2. mobile gas phase
What are the specific solvent systems used in both SN1 and SN2 portions of the Nucleophilic substitution lab?
SN1: AgNO3 in ethanol
SN2: NaI in acetone
What are the four solvent systems in the final step (solvent effects on SN1 rxn) of the nucleophilic substitution lab?
1:1 methanol:water
1:1 ethanol:water
1:1 acetone:water
1:1 1-propanol:water
How would you extract a nonpolar compound from its natural source?
Simple distillation
wash crystals with acetone
suction filtration
How do you calculate Rf value?
Distance traveled by compound/distance traveled by solvent front
Explain SN1 reaction
has carbocation intermediate that is stable. Most subsituted= most reactive. 2 step reaction that pulls from tertiary substituents
Explain SN2 rxn
No stable carbocation intermediate, 1 step reaction. Least substituted = most reactive because nothing to block incoming Nu-. Pull from 1 deg or 2 deg substituents
Four characteristics of a good solvent for recrystallization?
1. Must fully solvate your compound at high temperature, but not solvate it at room temperature
2. The impurities that you are removing from the mixture must be either soluble in the solvent at room temperature or insoluble at high temperature
3. The solvent must be chemically inert
4. The solvent must be suitably volatile