1/28
Looks like no tags are added yet.
what is melting point
temp when solid in equilibrium with liquid
how to identify melting point range
temp when crystals first start to liquify and when its done
melting point range of pure compounds
1-2 degrees C
presence of a soluble impurity will ______ the melting point
decrease
purpose of melting point
identify uk compound and determining purity
to find accurate melting point
heat slowly and use powdered sample
not preheating the gravity filtration apparatus will cause
lower percent recovery bc crystals form on apparatus instead of being filtered out
melting point procedure
1-2mm crystals in capillary tube
recrystallization
process to remove impurities from organic compounds
choose a good recrystallization solvent
compound dissolves easily at high temps
compound doesn’t dissolve at low temps
impurities should be soluble/insoluble at ALL temps
determine recrystallization solvent experiment
compound in solvent → room temp and solvent boiling point
c should dissolve at boiling point, not at room temp
oiling out
compound is insoluble in a solution at a temp above the compound’s melting point
solvent boiling point _____ compound melting point
less than
recrystallization procedure
5% excess compound added to prevent premature crystallization
dissolve acetanilide in hot solvent
acetanilide soluble in ethanol & acetone, insoluble in water and petroleum ether
add activated carbon to get rid of impurities
vacuum filtration to separate crystals from liquid
weigh crystals and measure melting point
percent recovery
mass recovered/starting mass * 100
purpose of separating acids and neutral compounds by solvent extraction
use solvent extraction techniques to separate a mixture consisting of a carboxylic acid, a phenol, and a neutral compound
extraction
occurs when desired compound changes layers, leaving behind impurities
extract
solution of dissolved compounds in solvent
two solvents must be
immiscible
washing aka
opposite of extraction, impurities change layers and leave behind desired compound

emulsion
suspension of small droplets of one liquid in another, liquids normally dont mix
gently swirling helps aqueous sodium chloride by
clearing emulsion formation
solvent extraction procedure
dissolve acetanilide, p-toluic acid and p-tert-butylphenol in t-butyl methyl ether
extract p-toluic from ether layer from NaHCO3 solution
extract p-tert from ether layer with NaOH solution
add HCl to NaHCO3 layer to isolate p-toluic acid
add HCl to NaOH layer to isolate p-tert-butylphenol
dry ether solution to isolate acetanilide
calculate Rf value
distance compound traveled/distance solvent traveled
extraction lab TLC solvent
ethyl acetate and methane
extraction lab TLC results
p-toluic has lowest Rf value bc its the most polar
purpose of thin-layer chromatography
identity of substance/components of mixture
progress of reaction
determine purity
size and polarity
rf value
less polar gives ______ Rf values
higher
TLC plate is polar silica gel so
polar substances don’t go up