Error Analysis

0.0(0)
Studied by 0 people
call kaiCall Kai
learnLearn
examPractice Test
spaced repetitionSpaced Repetition
heart puzzleMatch
flashcardsFlashcards
GameKnowt Play
Card Sorting

1/4

encourage image

There's no tags or description

Looks like no tags are added yet.

5 Terms

1
New cards

Precision vs. accuracy (and how to report measurements)

  • Precision: How close a series of replicate measurements are to each other

  • Accuracy: how close a measured value is to the true or accepted value

  • How to report measurements:

    • (best estimate) ± (uncertainty) (units)

    • OR (average) ± (standard deviation)


2
New cards

Difference between random error (uncertainty) and systematic error

  • Random error

    • happens because of uncontrollable variables like environmental fluctuations and natural variations when estimating the last digit of an instrument reading

    • Can either skew the data too high OR too low past the true value (reduces precision)

    • mitigated by replication of trials

  • Systematic error

    • A consistent and repeatable deviation between an observed measurement and the true value

    • Caused by flaws in an instrument, experimental setup, consistently reading a meniscus from above, etc.

    • Skews measurements in one consistent direction, reducing accuracy

    • Mitigated through refined technique


3
New cards

How is relative uncertainty (relative standard deviation) calculated

(standard deviation) / measured value

4
New cards

How is relative error (percent error) calculated?

((measured - actual) / actual) x 100%

5
New cards

Possible sources of error in 102L experiments (THR, COL, RTK1-2, EQB, ST1-3)

  • THR (thermochemistry/calorimetry)

    • Systematic: heat loss from heat escaping to the surroundings (from imperfect styrofoam cup insulation)

      • Solid NaOH absorbing moisture (hygroscopic)

    • Random: fluctuations in temperature prove readings or slight variations in manual timing when adding reactants

  • COL (colligative properties/freezing point depression)

    • systematic: supercooling of the solvent or solution before freezing actually starts (distorting the freezing point pleateu)

      • incomplete dissolution of the solute before freezing point depression measurements

    • Random: minor fluctuations in digital temperature sensor readings

  • RK1-2 (Chemical kinetics - rates and rate laws)

    • Systematic: time delay between mixing reagents and starting spectrophotometer data collection

    • Random: minor instrumental drift in detector readings or slight variations in initial pipetting volumes

  • EQB (equilibrium)

    • systematic: fingerprints, smudges, or scratches on cuvettes increasing measured absorbance

    • Random: slight meniscus (curved part of where you read measurements) variations in the dilution preparation

  • ST1-3 (seawater titrations)

    • Systematic: air bubbles trapped in burette tip that flush out in titration

      • consistently reading above or below burette meniscus

      • overshooting titration equivalence point

    • Random: natural fluctuation in estimating last decimal place on burette when titrating