1/28
Comprehensive vocabulary based on the ARCP 210 Module 9 Propeller Review lecture, covering constant speed theory, major propeller models, and maintenance standards.
Constant-speed propeller
A propeller that uses a governor to automatically adjust propeller blade angle, holding a pilot-selected RPM constant despite changes in airspeed or engine power.
Manifold Pressure (MP)
A measurement controlled by the throttle representing the power output of the engine and the air/fuel charge density in the cylinders.
Fine pitch
A low blade angle with less resistance, allowing the propeller to spin faster on less power.
Coarse pitch
A high blade angle with more resistance that absorbs more power and results in a slower RPM.
Under-Speed
A condition where flyweights rotate inward and the pilot valve shifts to direct oil to decrease blade angle (fine pitch).
On-Speed
A state where flyweights stay balanced and the pilot valve stays neutral, causing oil flow to stop and blade angle to hold steady.
Over-Speed
A condition where flyweights rotate outward and the pilot valve shifts to direct oil to increase blade angle.
Thrust Force
A force acting along the blade that tends to bend the blades forward in the direction of travel.
Centrifugal Force
The main force that blade retention must resist, pulling straight outward on the rotating blade mass.
Centrifugal Twisting Force
A force acting on the blade's offset center of gravity that twists the blade toward low (fine) pitch.
Aerodynamic Twisting Force
A force created when the center of pressure sits ahead of the pitch-change axis, twisting the blade toward high (coarse) pitch.
Blade Shank
The thick, rounded root section nearest the hub designed to give strength to the blade.
Blade Butt
The base of the blade that seats into the hub assembly.
Chord Line
The straight line from the leading edge to the trailing edge of the blade airfoil.
Angle of Attack
The angle between the relative wind and the chord of the blade.
Geometric Pitch
The theoretical forward distance a propeller would travel in one revolution if moving through a solid medium.
Effective Pitch
The actual forward distance the propeller travels through the air in one revolution, which is always less than geometric pitch.
Propeller Slip
The difference between geometric pitch and effective pitch caused by air not being a solid medium.
Hamilton Standard (Counterweight) High Pitch
Achieved when centrifugal force on the counterweights moves outward, forcing the piston in and increasing blade angle.
McCauley Non-Feathering
A propeller type where oil pressure increases blade angle and a red dye is used as a visible indicator of cracks.
Hartzell Compact Feathering Coarse Pitch
Achieved using nitrogen charge, internal spring pressure, and counterweights to move the blades.
Hartzell Automatic High Pitch Stops
Spring-loaded latches that block the blade from reaching feather on ground shutdown; they pull clear when centrifugal force exceeds 800RPM.
Unfeathering Accumulator
A component that stores pressurized oil to assist in rotating blades out of feather before engine oil pressure builds.
Hamilton Standard Hydromatic
A dual oil-pressure, cam-driven system that changes blade angle using opposing oil pressure forces without springs or counterweights.
Moisture Holes
Holes drilled in metal propeller tips to allow moisture to escape, preventing internal corrosion and imbalance.
Blade Tracking
The process of determining the position of the blade tips relative to each other, often identifying issues like a bent propeller flange.
Master Spline
A single spline shaped or sized differently from the rest to ensure the propeller hub is installed in the correct orientation.
Feathering
A condition with a very high pitch (90 degrees) used for emergencies or shutdown to stop forward thrust.
Dynamic Balancing
A maintenance check performed while the propeller is rotating (during a test flight) to catch vibrations.