INPUT POSITION FLOW CHART

0.0(0)
Studied by 0 people
call kaiCall Kai
learnLearn
examPractice Test
spaced repetitionSpaced Repetition
heart puzzleMatch
flashcardsFlashcards
GameKnowt Play
Card Sorting

1/17

encourage image

There's no tags or description

Looks like no tags are added yet.

18 Terms

1
New cards

Mic level input (-60db)

connection on a console that routes mic signal through phantom power, pad, and phase invert

2
New cards

Line (+4/-10)

the line-level inputs bypass the high-gain preamps necessary for microphone level signals, resulting in a shorter, purer signal path.

3
New cards

Phantom Power +48 V

System for delivering voltage typically used to power condenser microphones and other devices

4
New cards

Pad

The Pad attenuates the level of incoming signal so it won’t overload the circuit of the input position.

5
New cards

Phase invert (180 out of phase)

flips a signal’s polarity from positive to negative and vice versa, used of for phase cancellation

6
New cards

Transformer

Transformers are used in audio devices to step up or step down voltages to the required levels, as well as to isolate circuits

7
New cards

Pre Amp

on board amp used to raise a mic level signal to line level

8
New cards

Trim/Gain

Determines input gain for each channel (used for gain staging)

9
New cards

Mic line switch

switches the signal level the channel input will receive

10
New cards

EQ

Boosts or cuts the level of a particular frequency or range of frequencies

11
New cards

Insert Section

A connection that breaks out the signal of the input allowing an external processor to be inserted (Compressor, limiter etc)

12
New cards

Pre Fader Aux send

An aux bus which’s signal is not affect by the position go the channel fader

13
New cards

Fader

control that slides in a linear fashion and attenuates incoming signal

14
New cards

Post fader aux send

aux bus which’s signal is affected by the channel fader typically used as effects sends

15
New cards

Direct out

Output that routers a single channel out the board Direct outs are most commonly used to feed a channel’s signal to a recorder or DAW input

16
New cards

Panner

Varies the balance of a signal between the left and right mix outputs.

17
New cards

assignment matrix busses

Routes one or more signals to one or more outputs at once. It’s commonly used to send inputs to a multitrack recorder and can sum multiple inputs to one destination.

18
New cards

Active combining Network

Console circuitry that enables summing and keeps the combined signals balanced from their original source.