1/10
Vocabulary flashcards covering the structural definitions, geometric parameters, and load conversion formulas for roof rafters and purlins.
Rafters
A sloped beam that supports the entire roof of a building and also carries roof live loads and wind loads.
Purlins
A horizontal structural element (beam) found in a roof whose purpose is to resist wind loads and the weight of the roof; can be made of timber or steel (C shapes).
Pitch
The ratio of the height of the truss to the length of the bottom chord.
Roof Pitch Angle (θ)
The angle made by the rafter with respect to the horizontal.
Spacing of Purlins (s)
The on-center distance between adjacent purlins, typically expressed in meters (m) or feet (ft).
Roof Dead Load (wD)
The distributed dead load acting along a purlin, calculated as wD=PD(s), where PD is the roof dead load in pressure (kPa or psi) and s is the purlin spacing on center.
Normal Component of Dead Load (wn)
The component of the dead load acting perpendicular to the roof slope, measured in units of kN/m or lb/ft.
Tangential Component of Dead Load (wt)
The component of the dead load acting parallel to the incline of the roof, measured in units of kN/m or lb/ft.
Roof Live Load (wL)
The distributed live load converted to its equivalent along the incline, determined by wL=PL×LiLh or wL=PL×cos(θ)(s), where PL is the roof live load pressure.
Normal Wind Pressure (PN)
The pressure component normal to the roof surface, calculated from wind pressure using the formula PN=1+sin2(θ)2Psin(θ).
Normal Wind Load (wn)
The normal distributed load carried by a purlin due to wind, determined by wn=PN(s), where PN is the normal wind pressure and s is the spacing of purlins on center.