Module 5 ELECTRICAL

0.0(0)
Studied by 0 people
call kaiCall Kai
learnLearn
examPractice Test
spaced repetitionSpaced Repetition
heart puzzleMatch
flashcardsFlashcards
GameKnowt Play
Card Sorting

1/13

encourage image

There's no tags or description

Looks like no tags are added yet.

14 Terms

1
New cards

Given a 4" square box is 2¼" deep, what is the volume according to the NEC Article 314?

34 in³

2
New cards

What information is contained in the NEC Chapter 8?

Communications systems

3
New cards

When installing NM cable into a single gang box with an opening of 4" by 2¼", what is the minimum length of wire required outside the opening according to NEC Article 300?

6 inches

4
New cards

Which NEC section specifies that nonmetallic-sheathed (NM) cable must be supported within 12" of every box or cabinet?

NEC Section 334.30

5
New cards

Which is the NEC article that covers the general requirements for the grounding and bonding of electrical installations?

NEC Article 250

6
New cards

According to NEC Article 210, where must a listed wall-mounted control device be installed?

Between 15 and 48 inches above the floor

7
New cards

CSA and UL Solutions are examples of which of the following?

Nationally Recognized Testing Laboratories (NRTLs)

8
New cards

What does the NEC Article 200 contain information on?

Use and Identification of Conductors

9
New cards

Which NEC Chapter covers special occupancy areas?

NEC Chapter 5

10
New cards

The NEC safeguards people and property from the hazards of electricity by establishing minimum installation ______?

Requirements

11
New cards

According to NEC Article 300, what is the minimum burial depth for nonmetallic conduit under a single-family dwelling driveway?

At least 18 inches

12
New cards

Where in the NEC does it provide information, material, and examples that might be considered helpful but not mandatory?

Informational Notes

13
New cards

What type of rules are contained in the NEC?

Mandatory Rules

14
New cards

According to NEC Article 300, how far back from the edge must a hole be drilled in a stud if a nail plate is not being used?

At least 1¼ inches