A set of measurements is tightly clustered but far from the true value. These measurements are best described as:
Precise but not accurate
2
New cards
In a zero-baseline test, two receivers share one antenna through a splitter. What does this test check?
Receiver noise and bias, plus the processing software
3
New cards
Under the quadrant rule for selecting horizontal control, the project is divided into 4 quadrants and control should be used in at least how many of them?
3
4
New cards
Rain and overcast skies disrupt GNSS signal reception, so static sessions are normally cancelled in bad weather.
False
5
New cards
The main cycle of polar motion, the Chandler period, is approximately:
430 days (about 14 months)
6
New cards
Geodetic latitude (φ) is the angle between the equatorial plane and the:
Ellipsoid normal at the point
7
New cards
According to the lecture, the best way to transfer orthometric heights is by:
Spirit leveling
8
New cards
In the Earth-Centered, Earth-Fixed (ECEF) coordinate system, where is the origin located?
At the geocenter (the Earth's center of mass)
9
New cards
Geocentric latitude and geodetic latitude are equal only at the equator and at the poles.
True
10
New cards
The approximate coordinates written on a station visibility diagram are used as fixed control values in the final network adjustment.
False
11
New cards
Why do trivial (dependent) baselines add no redundancy to a network?
They are computed from the same session's data, so a loop made of one session's lines always closes at zero
12
New cards
Satellite data later showed that the origin of NAD83 is offset from the true geocenter by about:
2 m
13
New cards
In the ECEF system, the Z axis points toward the:
International Reference Pole (IRP)
14
New cards
GNSS receivers directly measure orthometric heights (elevations above the geoid).
False
15
New cards
The deflection of the vertical is the angle between the:
Plumb line and the ellipsoid normal at the same point
16
New cards
For relative static GNSS positioning, at least how many satellites must be tracked?
4
17
New cards
At setup, all antennas should be oriented in the same direction, usually north, to reduce phase center variation.
True
18
New cards
Which set of values is correct for the Universal Transverse Mercator (UTM) system in the northern hemisphere?
6° zones
19
New cards
Under the Geospatial Positioning Accuracy Standards (FGDC-STD-007-1998), accuracy is reported at what confidence level?
95% (2σ)
20
New cards
On a station visibility diagram (polar chart), the center of the chart represents:
The zenith (90°)
21
New cards
On an NGS data sheet, the PID (permanent identifier) of a passive station consists of:
2 letters followed by 4 numbers
22
New cards
Which satellite arrangement gives the best geometry (lowest PDOP)?
One satellite near overhead and the others spread out near the horizon
23
New cards
According to the Chapter 5 notes, a station's coordinates are completely and correctly defined only when which three items are given?
Reference frame, frame reference epoch, and coordinate (survey) epoch
24
New cards
What is the recommended minimum number of vertical control benchmarks for a project, and where should they ideally be located?
4 benchmarks, ideally at the project corners
25
New cards
High Accuracy Reference Networks (HARNs) were statewide GPS networks observed from the late 1980s through the 1990s in order to:
Upgrade NAD83 to GPS-level accuracy
26
New cards
In the label WGS84(G2139), what does "G2139" refer to?
The WGS84 realization based on GPS week 2139
27
New cards
What does the NGS tool HTDP (Horizontal Time-Dependent Positioning) do?
Moves coordinates between reference frames and between epochs using crustal-velocity models
28
New cards
In post-processed static GNSS surveying, stations must be intervisible.
False
29
New cards
The French arc-measuring expeditions of the 1730s to Lapland and Peru showed that:
A degree of latitude is longer near the pole, so the Earth is flattened at the poles
30
New cards
Which projection would normally be chosen for a State Plane zone that is long in the east–west direction, as in Texas?
Lambert Conformal Conic
31
New cards
Network (absolute) accuracy expresses uncertainty relative to:
A datum such as the National Spatial Reference System (NSRS)
32
New cards
A GNSS receiver in East Texas gives an ellipsoid height h = 110.25 m. The geoid model gives N = −27.40 m. What is the orthometric height H?
137.65 m
33
New cards
During one session, 5 receivers observe simultaneously. How many independent (nontrivial) baselines does the session produce?
4
34
New cards
The old first-order standard was 1:100,000. The FGCC AA-order standard is how many times more accurate than first order?
1000×
35
New cards
The Laplace correction listed on an NGS data sheet is used to:
Convert an astronomic azimuth to a geodetic azimuth
36
New cards
The Geodetic Reference System 1980 (GRS80) ellipsoid was adopted by the:
International Union of Geodesy and Geophysics (IUGG)
37
New cards
Vertical uncertainty is typically larger than horizontal uncertainty.
True
38
New cards
A session is named 49-1. What does this mean?
Day of year 49 (February 18), session 1
39
New cards
In the FGCC formula for estimating the number of sessions, what safety factor (k) is used for projects more than 100 km from the home base?
0.2
40
New cards
Which of the following is usually NOT a significant source of multipath?
Fast-moving traffic
41
New cards
NAVD 88 was fixed to a single tide gauge at Father Point/Rimouski, Quebec.
True
42
New cards
NAD27 was based on which ellipsoid, and what was its initial point?
Clarke 1866 ellipsoid
43
New cards
A horizontal ground distance is 2,000.00 ft. The elevation factor is 0.99995 and the grid scale factor is 0.99992. What is the grid distance? (Round to 0.01 ft.)
1,999.74 ft
44
New cards
In a secant projection, the scale factor is greater than 1 between the two lines where the projection surface cuts the ellipsoid.
False
45
New cards
Loop closures are only meaningful when the loops:
Combine baselines from different sessions
46
New cards
In the conterminous United States, the geoid lies below the GRS80 ellipsoid, so the geoid height (N) is negative.
True
47
New cards
According to the lecture, what is the most common blunder in GNSS field work?
A mismeasured antenna height (H.I.)
48
New cards
Which formula gives the flattening (f) of an ellipsoid with semi-major axis a and semi-minor axis b?
f = (a − b) / a
49
New cards
The mask angle used in static GNSS planning is usually:
15°–20°
50
New cards
A conformal (also called orthomorphic) map projection preserves: