1/42
Looks like no tags are added yet.
Name 3 developable surfaces in map making.
Cylinder, Cone, Plane
True or False: Both Lambert Conformal Conic and Azimuthal projections are used in the state plane coordinate system.
False
True or False: UTM zones are 3 degrees wide.
False
How many degrees wide are UTM zones?
6 degrees
True or False: A 3D Cartesian Z coordinate on the Earth’s ellipsoid is always less than or equal to the Earth’s equatorial radius.
True
True or False: A 3D Cartesian X coordinate on the Earth’s ellipsoid is always less than or equal to the Earth’s equatorial radius.
True
True or False: There is no way to limit distortion on map projections, it is the same over all sizes of maps
False
When looking at the circumference measurement of an ellipsoid, is measurement a or b larger?
Measurement a is larger than measurement b
What direction are meridians oriented?
They run/are oriented north to south, they measure different location based on an east to west degree.
True or False:UTM zones have a 0 Easting value all along their eastern edge
False
True or False: Each projection has both a forward and an inverse, from latitude/longitude to projected coordinates, and from projected coordinates to latitude/longitude.
True
True or False: The most precise positional measurements must record the epoch, or time of measurement to account for continental drift.
True
True or False: Grid north is in the direction of the north pole
False
True or False: Each projection defines a different geographic, latitude/longitude north.
False
True or False: Geographic north is equal to grid north over most areas of the UTM projection
False
True or False: All UTM South zones have a 0 Northing value all along their southern edge
False
True or False: State plane zone boundaries change through time
True
True or False:The central meridian in Lambert conformal conic projections used in the state plane coordinate system always points toward grid north
True
True or False: The PLSS is a common projection used in western states of the U.S.
False
True or False: A projection is a statistically fit transformation from one coordinate system to another, so you might not end up with your original values if you apply a forward transformation, then apply the reverse transformation.
False
True or False: Most commonly-used projections have a standard 4 or 5-digit identifier known as a PLSS number
False
When observed from an airplane, much of central and western United States appears to be organized with a "grid" like pattern. Why is this?
Because roads and property boundaries have been developed to be compatible with a Public Land Survey System, placed on the edge of property boundaries
True or False: You can sometimes mix data layers that are based on different datums, depending on the datums and your tolerance for spatial error
True
True or False: All UTM North zones have a 0 Northing value all along their southern edge
True
True or False: A projection from on coordinate system to another projected coordinate system must involve a datum transformation.
False
A 3D Cartesian Y coordinate on the Earth’s ellipsoid is always less than or equal to the Earth’s equatorial radius.
True
True or False:A datum shift for a point means the physical location of the point has shifted relative to other points
False
True or False: Grid north lines are parallel when plotted on a globe
False
True or False: Meridians are parallel.
False
True or False: You can sometimes mix data layers that are based on different datums, depending on the datums and your tolerance for spatial error
True
True or False: Each projection defines a different geographic, latitude/longitude north.
False
True or False: Some UTM South zones can have positive and negative eastings
False
Vector objects are discrete or continuous?
Discrete