1/22
Vocabulary flashcards covering aircraft landing gear arrangements, hydraulic system components, and electrical generation, distribution, and safety systems for large aircraft and light training airplanes.
Tricycle Gear
A landing gear configuration consisting of two main wheels under the center of the fuselage and a single nose wheel at the front, linked to rudder pedals for steering.
Toe-in
A wheel alignment adjustment where the front of the landing gear tires points slightly inward toward the aircraft's centerline.
Conventional Gear (Taildragger)
A landing gear layout featuring two main wheels positioned forward of the center of gravity and a small wheel supporting the tail.
Tandem / Bicycle Gear
A gear configuration where main gear units are aligned in a straight line along the longitudinal centerline of the fuselage, typically utilizing small outrigger wheels on the wingtips to prevent tipping.
Mechanical Downlocks
Heavy mechanical linkages that physically freeze the landing gear in place when extended to prevent it from collapsing under the aircraft's weight.
Squat Switch (Weight on Wheels)
An electrical switch mounted on the landing gear strut that breaks the circuit to the gear retraction handle when compressed on the ground, preventing accidental retraction.
Three Green
A cockpit indication where three microswitches illuminate three green lights to confirm that the left main, right main, and nose gear are down and locked.
Manual Gear Extension Handle
An emergency control that opens a bypass valve to release hydraulic pressure, allowing gravity and airflow to deploy and lock the landing gear.
Oleo Strut
A shock absorber piston cylinder filled with nitrogen gas and hydraulic fluid; fluid forced through a tiny hole cushions touchdown impacts while compressed nitrogen absorbs taxi shocks.
Shimmy Damper
A small hydraulic shock absorber installed on the nose gear to suppress violent, rapid side-to-side wheel vibrations during taxiing and takeoff.
Hydraulic Accumulator
A sealed chamber storing hydraulic fluid under pressure against compressed nitrogen gas, functioning as an emergency backup pressure source and shock absorber to smooth pressure surges.
Skydrol
A purple-dyed synthetic phosphate-ester hydraulic fluid that cannot be mixed with red-dyed mineral-based fluids without destroying rubber seals.
Integrated Drive Generator (IDG)
The primary electrical power generator mounted directly to an aircraft jet engine, producing high-power Alternating Current (AC) at 115 Volts and 400Hz.
Auxiliary Power Unit (APU)
A small jet engine located in the aircraft's tail cone that drives a generator to supply electrical power and air conditioning while parked at the gate.
Ram Air Turbine (RAT)
An emergency backup propeller that deploys from the belly into the open airstream to generate critical hydraulic and electrical power during complete engine failure.
Transformer Rectifier Unit (TRU)
An electrical converter that transforms high-voltage Alternating Current (AC) into Direct Current (DC) using diodes to prevent reverse current flow.
Inverter
An electrical device that converts Direct Current (DC) power from aircraft batteries into Alternating Current (AC) power.
Electrical Bus (Bus Bar)
A central metal distribution strip that distributes electrical current from power generation sources to multiple connected instruments and components.
Load Shedding
The automatic process of disconnecting non-essential electrical buses during an emergency to preserve remaining battery power for critical flight systems.
Starter Solenoid
A heavy-duty relay switch that uses a low-current signal from the ignition switch to close the circuit carrying massive current from the battery to the starter motor.
Voltage Regulator
A component that controls alternator output to keep electrical system voltage constant at approximately 28 Volts regardless of engine speed.
Avionics Master Switch
A dedicated cockpit switch used to isolate sensitive radios and navigation equipment from high electrical surges during engine startup.
Magnetos
Independent, engine-driven mechanical generators that supply electrical current directly to spark plugs, allowing the aircraft engine to run without relying on the battery or alternator.