1/16
Looks like no tags are added yet.
Two types of termination
-for convenience
-for default
Termination for convenience usually expressed as the right of the:
owner
Termination for convenience allows the owner to:
stop contractor's right to complete or continue the work
Federal Acquisition Register (FAR) requires:
all federal contracts include provisions giving Government the right to terminate if CO determines termination is in Government's best interest
what is "convenience" ?
-Could be conflict of personalities
-Can see that contractor cannot proceed without losses
limitations on right to terminate for convenience
•No bad faith (O can't terminate at 90% complete to avoid paying)
•Cannot abuse discretion
Termination for Default or Cause
•Is a remedy that exists even if the contract is silent
•Available in response to material breach
Does a non-material breach qualify for termination?
hell no
•Events that allow Owner to terminate for Default:
•Sub-standard, defective or nonconforming work
•Failure to pay subs/suppliers
•Failure to pursue work diligently
•Violation of laws/ordinances
•Events allowing Contractor to terminate:
•Stoppage of work by Government through no fault of contractor or any of its forces for more than 30 days
•O has not furnished reasonable evidence of financial arrangements to fulfill its obligations under the contract
•Failure of contractor to pay subs
•Failure to follow the design documents as a material breach
•Timeliness when Time is of the Essence clause
•Anything the contract says (like failure to carry insurance)
wrongful termination
•If no justification for termination under either contract law or the contract itself
•Relieves contractor/sub for preceding breaches
•Discharges surety of any obligation under performance bond
•Contractor is entitled to be made whole and restored to the position it would have been in had the contract been performed.
T/F: Wrongful termination is not itself a breach of contract
False
Wrongful termination- government
Government can avoid paying contractor's anticipated profits by declaring the termination for convenience. This would limit contractor's recovery to costs of work completed at the time of termination.
Notice of termination
•Assess the factual & legal accuracy of the notice (compare it to your contract)
•Attempt to Cure
•Treat an improper termination notice as an acceleration order
•Notify Surety
Direct damages for termination
•O: hiring replacement contractor, delays, lost profits, add'l costs of completion, add'l costs related to admin of project/project mgmt
•Contractor: cost of work to pt of term plus overhead, lost profits
Consequential damages for termination
•All others to place non-breaching party in the same position it would have been in should the contract have been completely performed by the parties.
Alternative contract damages approach clauses
•Liquidated Damages
•"No Damages for Delay"
•Limitation of Liability