1/11
Vocabulary flashcards covering mass diffusion resistance, heat-mass analogies, interface boundary conditions, Raoult's law, Henry's law, and gas-solid solubility based on the lecture.
Stationary Medium Approach
An approximation used when the mole fraction of species a (xa) is very small, allowing the total concentration of the host medium (c) to remain constant and be taken inside the derivative.
Mass Diffusion Resistance
The resistance to mass transfer through a medium, formulated for a plane wall as A⋅DABδ with SI units of s/m3, analogous to thermal conduction resistance.
Mass Diffusivity (DAB)
A mass transport property that is typically constant without concentration dependence (in the absence of strong temperature or pressure gradients), analogous to thermal conductivity (λ) in heat conduction.
Series Resistance Rule in Mass Diffusion
The principle that mass diffusion resistances cannot typically be summed in series across different media because of concentration discontinuities at the interfaces.
Raoult's Law
A relationship used at the interface during evaporation or sublimation stating that the gas-side partial pressure equals the interface liquid or solid mole fraction multiplied by the saturation pressure: pa,0=xa⋅psat,a(Ts).
Henry's Law
A thermodynamic relationship for a gas dissolving into a liquid at dilute concentrations and moderate pressures (below 5bar), defined by xa=Hpa,0.
Henry's Constant (H)
A temperature-dependent parameter typically expressed in units of bar, specific to a particular gas-liquid pair in Henry's law.
Solubility (S)
The proportionality factor relating the concentration of species a in a solid to its gas-side partial pressure (ca=S⋅pa), typically expressed in units of kmol/(m3⋅bar).
Sieverts' Law
A law governing the dissolution of dissociating gas species (such as diatomic hydrogen, H2) into a solid, where the solid-phase concentration is proportional to the square root of the gas partial pressure.
Fick's Law Phase Restriction
The rule establishing that Fick's law is valid only within a single phase and cannot be applied directly across an interface between two different phases.
Concentration Discontinuity
An apparent jump in concentration observed across phase interfaces resulting from the concentration values being defined relative to different reference volumes (e.g., volume of solid versus volume of gas).
Partial Pressure Driving Force
The continuous thermodynamic driving force for mass transfer across multiple phases that decreases continuously without phase-volume reference discrepancies.