1/40
Comprehensive vocabulary flashcards covering the classifications, construction, operational principles, stress types, and specialized designs of modern steam boilers.
Steam Boiler
A closed vessel containing water that is pressurized and turned into steam when heat is added.
Enthalpy
The total heat in steam calculated from a specific reference point, usually 32∘F.
Low Pressure Steam Boiler
A boiler used primarily for heating buildings and domestic water, having a maximum allowable working pressure (MAWP) of 15 psi.
High Pressure (Power) Steam Boiler
A boiler that operates at a pressure above 15 psi and over 6 boiler horsepower (BHP), commonly used for electric power generation and industrial processing.
Boiler Horsepower (BHP)
The evaporation of 34.5 lb of water per hour from and at a feedwater temperature of 212∘F.
Sensible Heat
Heat that can be measured with a thermometer or sensed by a person, which raises the temperature of a substance without causing a change of state.

Firetube Steam Boiler
A boiler in which heat and gases of combustion pass through tubes that are surrounded by water.

Heating Surface
The part of a boiler that has water on one side and heat and gases of combustion on the other.
Thermal Efficiency
The ratio of the heat absorbed by the water in the boiler to the total heat available in the fuel.
Horizontal Return Tubular (HRT) Boiler
A type of firetube boiler consisting of a drum suspended over a firebox, using through stays and diagonal stays to support flat tube sheets.

Scotch Marine Boiler
A firetube boiler featuring an internal furnace completely surrounded by water, which can be configured with baffles into a two-, three-, or four-pass boiler.
Vertical Firetube Boiler
A one-pass firetube boiler requiring minimal floor space and high ceiling clearance, with a combustion chamber supported by staybolts.
Waterleg
A water-filled compartment formed between the inner and outer wrapper sheets surrounding the combustion chamber of a vertical firetube boiler.
Sludge
Accumulated residue produced by impurities present in boiler water.
Sediment
Particles of foreign matter present in boiler water.
Dry-Top Boiler
A vertical firetube boiler in which the upper ends of the tubes and upper tube sheet are not submerged in water, causing the steam to be slightly superheated.
Wet-Top Boiler
A vertical firetube boiler in which the upper tube sheet and tubes are completely submerged in water, preventing steam superheating.
Watertube Steam Boiler
A boiler in which water circulates inside the tubes while heat and gases of combustion pass around the outside of the tubes.
Critical Pressure of Steam
The pressure point of 3206 psi at which the density of water and steam become identical.
Low Pressure Hot Water Heating Boiler
A boiler that heats water for the purpose of supplying heated water at pressures not exceeding 160 psi and temperatures not exceeding 250∘F.
Power Hot Water Boiler
A boiler used for heating water or liquid to a pressure exceeding 160 psi or to a temperature exceeding 250∘F.
Small Power Boiler
A boiler with an operating pressure exceeding 15 psi but not exceeding 100 psi, and having a heat input of less than 440,000 Btu/hr.
Compressive Stress
A internal stress that occurs when two forces of equal intensity push toward the center of an object from opposite directions.
Shear Stress
A stress that occurs when two forces of equal intensity act parallel to each other but in opposite directions.
Tensile Stress
A stress that occurs when two forces of equal intensity act on an object, pulling in opposite directions.
Tube Beading
The process of rolling and rounding over the protruding ends of firetubes against the tube sheet to prevent the tube ends from burning.
Rifled Boiler Tubes
Tubes manufactured with internal helical ridges to induce fluid turbulence, which increases heat transfer efficiency in waterwall tubes.
Package Boiler
A self-contained, factory-assembled boiler unit equipped with feedwater and fuel accessories, burner assembly, and controls, ready for rapid installation.
Field-Erected Boiler
A large capacity industrial or utility boiler that must be assembled piece by piece directly on the job site.
Resistance Coil Electric Boiler
An electric boiler that generates heat by passing an electric current through coiled electrical resistance conductors.
Electrode Electric Boiler
An electric boiler that produces heat by passing electric current directly between electrodes submerged in the boiler water.
Membrane Boiler
A compact, gastight boiler constructed from shaped metal alloy sheets welded together, between which combustion gases travel to heat water.
Flex-Tube Boiler
A watertube boiler featuring replaceable tubes shaped in an S-curve at the top to allow for vertical thermal expansion and contraction.
Condensing Boiler
A high-efficiency hot water heating boiler designed to extract the latent heat of vaporization (970 Btu/hr/lb) by condensing water vapor from flue gas.
Waste-Fuel Boiler
A boiler designed with specialized burners to consume industrial byproducts such as sawdust, bark, wood waste, or black liquor residue as its primary fuel source.
Refuse-Derived Fuel (RDF) Boiler
A refuse boiler where municipal solid waste is combusted outside the boiler furnace and the resulting gases are directed into the furnace to burn.
Mass Burning Boiler
A refuse boiler that receives and incinerates unsorted or minimally sorted municipal solid waste directly inside the boiler furnace.
Super Boiler
An advanced industrial boiler system developed under the DOE Industrial Technologies Program delivering 93% to 94% efficiency, with NOx below 9 ppm and CO below 10 ppm.
Baffles
Internal partitions designed to divert and direct combustion gases across the boiler heating surface to maximize heat transfer.
Waterwall
A series of closely spaced watertubes lining the combustion chamber to absorb radiant heat and protect the refractory furnace walls.
Mud Drum
The lowest drum on the water side of a watertube boiler where sludge and sediment settle for removal via blowdown.