1/29
Vocabulary practice flashcards covering fundamental electronics, Arduino hardware, breadboards, soil moisture sensing, and HC-SR04 ultrasonic distance measurement.
Wire
The conductor that provides the best and most effective pathway for electricity to travel through a circuit.
Switch (OFF State)
A state in a circuit that interrupts the connection, causing electricity to stop flowing.
Arduino
An open-source programmable microcontroller board used to build interactive electronic devices and projects.
Microcontroller
A tiny computer inside an electronic device that follows programmed instructions to process inputs and control outputs.
Open-Source
A model where the hardware design or software code is shared publicly so anyone can study, use, modify, and distribute improvements subject to licensing.
Microcontroller Operation Steps
The three-step control process consisting of Input (receiving data from buttons or sensors), Process (evaluating program instructions), and Output (triggering an action such as lighting an LED or sounding a buzzer).
Digital Pins (Arduino)
Pins on the Arduino board that can be set to HIGH (ON) or LOW (OFF) to send binary signals and control external devices.
Analog Pins (Arduino)
Pins on the Arduino board designated to read a continuous range of varying sensor values (such as from A0).
USB Port (Arduino)
The hardware interface used to connect the Arduino board to a computer for programming and power.
Tinkercad
A free, web-based platform used for designing and simulating Arduino circuits virtually.
LED (Light Emitting Diode)
A semiconductor component that emits light when electric current flows through it in the correct direction.

Anode
The longer lead of an LED that connects to the positive (+side) of a circuit.
Cathode
The shorter lead of an LED that connects to the negative (−side) or ground of a circuit.

Resistor
A component that limits the flow of electric current in a circuit to protect sensitive parts like LEDs from damage; measured in ohms (Ω).

Breadboard
A construction base with holes that allows electronic components and jumper wires to be connected temporarily to build circuits without soldering.
Power Rails (Bus Lines)
The long outer columns on a breadboard tied together vertically to distribute power (5V) and ground (GND).
Terminal Strips
The rows of five interconnected holes on a breadboard that allow electricity to flow between components inserted into the same row.
Center Divider
The central groove separating the two sides of a breadboard, isolating the terminal rows on one side from the other.
GND (Ground)
The common return path that completes an electrical circuit.
Conductivity
The measure of how easily electricity passes through a material; dissolved minerals in water increase electrical conduction through soil.

Soil Moisture Sensor
An electronic device with two conductive metal probes that estimates soil water content by measuring how well the soil conducts electrical current.
Dry Soil Sensor Reading
A high analog sensor reading caused by low water content, which makes it harder for electric current to pass between the conductive probes.
Wet Soil Sensor Reading
A lower analog sensor reading produced because abundant water with dissolved minerals conducts electricity easily between the probes.

Threshold
A specific numerical value or set limit that marks the decision point where an Arduino changes state (such as switching an LED from OFF to ON).

Ultrasonic Sensor (HC-SR04)
A module that calculates distance to an obstacle by emitting and detecting high-frequency sound waves beyond human hearing.
Trigger Pin (Trig)
The pin on the HC-SR04 ultrasonic sensor that transmits the ultrasonic sound pulse into the air.
Echo Pin
The pin on the HC-SR04 ultrasonic sensor that detects and receives the reflected sound wave bounced off an object.
Speed of Sound in Air
The velocity of sound at room temperature, approximately 343m/s (or 0.034\,\text{cm/\mu s}).

Ultrasonic Distance Formula
d=2v×t, where velocity v is multiplied by the round-trip time t and divided by 2 to calculate the one-way distance to the target.

HC-SR04 Wiring Connections
The standard wiring setup connecting HC-SR04 VCC to Arduino 5V, GND to GND, Trig to digital Pin 9, and Echo to digital Pin 8.